P20BA

P20BA on a 2011–2016 GMC Sierra HD: Reductant heater A control circuit performance

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: P20BA on a 2011–2016 Chevrolet Silverado HD · 2011–2019 Ford F-250 · 2011–2016 Ford F-350 · 2011–2016 GMC Sierra HD

DIY difficulty 4/5

On your diesel, reductant heater A - which keeps the diesel exhaust fluid from freezing - is not performing properly. The SCR system may be disabled.

Key facts

☑ Before you buy parts — check these first:
On your 2011–2016 GMC Sierra HD (6.6L LML Duramax V8 diesel) — DEF tank heater failure (P20B9/P20BA) and countdown-to-limp: Owner-verified
DIY-friendly with a capable scan tool for the post-repair reset. A YouTube walkthrough shows the full P20B9 heater replacement on a Duramax.
Do this test first: Check for technical service bulletins for your vehicle.
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P20BA on the 2011–2016 GMC Sierra HD — but the community-sourced DEF tank heater failure (P20B9/P20BA) and countdown-to-limp note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Torque specs

Tips

Sources: JustAnswer: 2012 GMC 2500 6.6 diesel P20B9, DEF heater replacement and reset · JustAnswer: 2011 Silverado 6.6 P20B9 heater ohm-check procedure · YouTube: P20B9 Duramax - Full Repair of DEF Heater

Typical difficulty: Involved — based on 72 code guides for the scr repair area (an area-level estimate, not this exact job).

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Owner notes linked to P20BA: 4 across 2 repairs — these are counts of owner-written notes, not odds of fixing your car.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 7 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check for technical service bulletins for your vehicle.
  2. Visually inspect the reductant heater system harnesses and connectors - repair burnt or damaged wiring first. Tests: Bad reductant heater (most common)
  3. Retrieve all codes and freeze frame data, clear the codes, and test drive.
  4. Test the power supply to the SCR control system and test fuses with the circuit loaded. Tests: Open or shorted circuits in the reductant heater control
  5. Use the scanner to activate the reductant heaters and test the output control circuit voltage.
  6. Test the reductant heater element against the manufacturer's specifications.
  7. If the code appears in warm weather, suspect a programming error.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2011–2016 GMC Sierra HD: DEF tank heater failure (P20B9/P20BA) and countdown-to-limp — test first, then buy for this job.
The price range below is a national planning range for P20BA on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$150 – $800
Labor$150 – $400

Reductant heater A replacement or wiring repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P20BA ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

4 of 5 — Visual inspection of the heater and its wiring is DIY-friendly; tracing the full SCR control circuit needs a wiring diagram.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: Sensor mounting bolts: typically 8–12 Nm — verify spec. Never overtighten sensors with plastic bodies.

Pro tip: Check wiring and connectors first — chafed wires and corroded pins cause more sensor codes than dead sensors do.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →