P2067

P2067: Fuel level sensor B circuit low input

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The secondary fuel gauge sender (B circuit) is reading too low - usually a wire shorted to ground or a shorted-out sender. The gauge may read empty all the time even with a full tank.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 8 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check for technical service bulletins for your make and model.
  2. Locate the fuel level sensor on your vehicle (usually in the fuel tank or on the fuel pump module). Tests: Failed fuel level sensor / internally shorted (most common)
  3. Visually inspect the connector and wiring at the tank for scraping, rubbing, bare wires, corrosion, or melted plastic. Tests: Corroded connector or wiring at the fuel tank
  4. Clean the terminals with electrical contact cleaner, let dry, and apply dielectric grease.
  5. Clear the codes and see if P2067 returns - if not, the connections were the problem.
  6. If it returns, test the sensor signal voltage and ground against the factory specs with a multimeter.
  7. If the sensor resistance is out of spec, replace the fuel level sensor.
  8. Only suspect the PCM after the sensor and wiring are proven good.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$50 – $400
Labor$200 – $600

Fuel level sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2067 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Connector inspection and cleaning at the tank are easy; replacing the sender means dropping the tank or removing the pump module, which is a bigger job.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: Sensor mounting bolts: typically 8–12 Nm — verify spec. Never overtighten sensors with plastic bodies.

Pro tip: Check wiring and connectors first — chafed wires and corroded pins cause more sensor codes than dead sensors do.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →