Diagnose soonThe SCR system can be disabled, which raises emissions and can damage the catalyst if ignored - get it diagnosed promptly.
The DEF tank temperature sensor reading does not look believable - usually a failing sensor or damaged wiring. The system cannot manage DEF heating properly, so the SCR system can shut down.
Key facts
P205B means reductant tank temperature sensor circuit range/performance. The DEF tank temperature sensor reading does not look believable - usually a failing sensor or damaged wiring. The system cannot manage DEF heating properly, so the SCR system can shut down. WrenchFair's published fair-price range for this repair is $100–$500 parts and $150–$450 labor at independent shops.
WrenchFair rates P205B a 4-of-5 DIY difficulty (“Connector inspection and sensor replacement are manageable if the sensor is accessible; circuit testing needs the factory flowcharts.”) with a “Diagnose soon” driveability rating: The SCR system can be disabled, which raises emissions and can damage the catalyst if ignored - get it diagnosed promptly. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2011–2016 GMC Sierra HD (6.6L LML Duramax V8 diesel) — DEF tank heater failure (P20B9/P20BA) and countdown-to-limp:Owner-verified
DIY-friendly with a capable scan tool for the post-repair reset. A YouTube walkthrough shows the full P20B9 heater replacement on a Duramax.
Do this test first: Check for technical service bulletins for your make and model.
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P205B on the 2011–2016 GMC Sierra HD — but the community-sourced DEF tank heater failure (P20B9/P20BA) and countdown-to-limp note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
DEF heater assembly fasteners: verify — Use factory service torque; the DEF pump injector nipple is fragile and breaks easily if forced.
Tips
On the 2011-2016 LML, a failed DEF (reductant) tank heater sets P20B9 (heater 1 control circuit), P20BA (heater A performance), or P205B and starts a countdown that eventually limits the truck to 55 mph, then 4 mph. Clearing the code does not stop the countdown; the heater itself has to be fixed.
Diagnose before buying parts: disconnect and ohm-check the heater element. It should read roughly 2-4 ohms (about 2.1 ohms on a good unit). A reading near 5 ohms or open means one of the two parallel elements has burned out and the heater is weak enough to set the code even though it still draws some current.
Replacement is a driveway job but cleanliness is everything: pressure-wash around the DEF tank first, because any dirt that falls in during the repair will clog the DEF injector or pump downstream and turn a heater job into a much bigger one. Drain the tank below the heater access, mark the fill and return lines before disconnecting, and reconnect them exactly as they came off.
After the repair the code will not stay cleared until the system is reset properly with a capable scanner: reset the reductant fluid tank level, run a reductant system leak test (system pressure should be in the 61-83 PSI range), and command each reductant heater on for about 10 seconds to verify operation.
While you are in there, inspect the tank temperature sensor and the wiring harness for damage or corrosion, and refill with fresh DEF. A 2012 GMC 2500 owner thread confirms the exact same P20B9 limp-countdown behavior and the reset sequence needed after the heater swap.
Typical difficulty: Involved — based on 72 code guides for the scr repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
check engine light on
reduction in fuel efficiency
excessive black smoke from the exhaust
diminished engine performance
other SCR-related codes
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Defective reductant tank temperature sensor (most common)
Open or shorted circuits in the sensor wiring
Corroded connector pins
Bad SCR controller/PCM or programming error (rare)
Owner notes linked to P205B: 2 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 6 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check for technical service bulletins for your make and model.
Inspect the tank temperature sensor connector for damage, corrosion, and a disconnected plug. Tests: Defective reductant tank temperature sensor (most common)
Retrieve all codes and freeze-frame data, record it, clear the codes, and drive to see if P205B resets.
Test the temperature sensor against the factory specs and replace it if it is out of range. Tests: Defective reductant tank temperature sensor (most common)
If the sensor tests good, test the input and output signal circuits between the sensor and the PCM/SCR controller with the controllers disconnected.
Only suspect the controller or PCM after the sensor and wiring are all proven good.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2011–2016 GMC Sierra HD: DEF tank heater failure (P20B9/P20BA) and countdown-to-limp — test first, then buy for this job.
The price range below is a national planning range for P205B on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$100 – $500
Labor$150 – $450
Reductant tank temperature sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P205B ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — Connector inspection and sensor replacement are manageable if the sensor is accessible; circuit testing needs the factory flowcharts.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →