Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonAddress this promptly - sustained over-temperature can melt the catalyst and turn a sensor or DEF problem into a multi-thousand-dollar exhaust replacement.
The catalytic converter on the cylinder-1 side of your diesel is running too hot. That usually means the exhaust-fluid system that manages regeneration temperatures is not working right, or a temperature sensor is lying. Get this checked soon - a cooked catalyst is one of the most expensive parts under the truck.
Key facts
P200E means catalyst system over temperature (bank 1). The catalytic converter on the cylinder-1 side of your diesel is running too hot. That usually means the exhaust-fluid system that manages regeneration temperatures is not working right, or a temperature sensor is lying. Get this checked soon - a cooked catalyst is one of the most expensive parts under the truck. WrenchFair's published fair-price range for this repair is $60–$3000 parts and $150–$600 labor at independent shops.
WrenchFair rates P200E a 4-of-5 DIY difficulty (“DEF and sensor checks are DIY-friendly, but verifying real catalyst temperatures against sensor data takes an infrared thermometer and a scan tool - and a damaged catalyst is a shop job.”) with a “Diagnose soon” driveability rating: Address this promptly - sustained over-temperature can melt the catalyst and turn a sensor or DEF problem into a multi-thousand-dollar exhaust replacement. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light on
diminished engine performance
excessive black smoke from the exhaust
reduction in fuel efficiency
other emission-related codes stored
Likely causes
Incorrect or insufficient diesel exhaust fluid (most common - check the DEF tank first)
Faulty SCR injector upsetting temperature control
Defective exhaust temperature sensor giving false readings
Inoperative SCR system or bad SCR controller
Exhaust leak ahead of the catalyst
Aftermarket or high-performance exhaust components
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 6 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
If any SCR codes are stored, diagnose those first; repair any exhaust leaks ahead of the catalyst before anything else. Tests: Exhaust leak ahead of the catalyst
Check for technical service bulletins for your make and model.
Confirm the DEF reservoir is full of the correct fluid and the SCR system is actually injecting.
Visually inspect the SCR injector, exhaust temperature sensors, NOx sensors, and oxygen sensor wiring and connectors for burnt or damaged wiring. Tests: Defective exhaust temperature sensor giving false readings
Use an infrared thermometer to measure actual pre- and post-catalyst temperatures and compare them to the scanner data and between banks.
Test any sensor that disagrees with the thermometer against the factory specs; if all sensors and wiring check out, suspect a failing catalyst element or SCR system.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$60 – $3000
Labor$150 – $600
Exhaust temperature sensor or SCR injector replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P200E ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — DEF and sensor checks are DIY-friendly, but verifying real catalyst temperatures against sensor data takes an infrared thermometer and a scan tool - and a damaged catalyst is a shop job.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →