P2028

P2028: EVAP fuel vapor temperature sensor circuit intermittent

DIY difficulty 2/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The sensor watching fuel-vapor temperature keeps cutting in and out - usually a loose connector, a pin not seated, or a wire that only breaks contact sometimes. The car drives fine, but the light will come and go and it will fail an emissions test.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Locate the fuel vapor temperature sensor and firmly check every connector in its circuit - loose pins, broken lock tabs, and poorly seated fuses are the top suspects. Tests: Loose connector pin, broken lock tab, or poorly seated fuse/connector in the sensor…
  2. Inspect the harness for chafing and the connector pins for corrosion or melting; repair as needed. Tests: Corroded or melted connector pins
  3. With a scan tool watching the sensor reading, wiggle the harness and connectors to try to reproduce the dropout. Tests: Loose connector pin, broken lock tab, or poorly seated fuse/connector in the sensor…
  4. Clear the code and drive normally to see if it returns.
  5. If it returns with the wiring proven good, test the sensor itself per the factory pin-out procedure.
  6. Only suspect the ECM after the sensor, wiring, and connectors are all proven good.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$30 – $200
Labor$100 – $300

Connector repair or EVAP fuel vapor temperature sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2028 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — Intermittent faults need a wiggle test while watching live data; the connector inspection itself is easy, but be gentle with brittle EVAP lines.

Watch this repair on YouTube

Parts & tools

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →