P0E7F

P0E7F: Coolant Bypass Valve B Control Stuck/Open

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The coolant bypass valve control was told to close but never did, so that electrical path stays dead. The car limits power to protect itself from heat.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 5 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. 1. Clear the code and confirm it returns under the same conditions before replacing anything.
  2. 2. Inspect the coolant bypass valve b control connector and wiring for damage or corrosion; check related fuses. Tests: control module driver fault (rare)
  3. 3. Command the coolant bypass valve b control on and off with a scan tool while listening or watching for actuation. Tests: control module driver fault (rare)
  4. 4. Check the control-side wiring and 12V supply per the service manual - a missing command signal points at wiring or the module, a present signal with no movement points at the coolant bypass valve b control itself. Tests: control module driver fault (rare)
  5. 5. Replace the faulty coolant bypass valve b control and verify it actuates on command.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$40 – $400
Labor$100 – $300

Replacing the stuck coolant bypass valve b control. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0E7F ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Coolant and electrical checks are DIY-friendly; internal valve or pump replacement varies by vehicle.

Watch this repair on YouTube

Parts & tools

Cooling system toolkit — what the job actually takes

Torque specs: Thermostat housing bolts: typically 8–12 Nm. Aluminum threads strip easily — verify spec and use a torque wrench.

Pro tip: Bleed the cooling system per the factory procedure after refilling, or trapped air will overheat the engine and fake a “still broken” reading.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →