P0E13

P0E13: Hybrid/EV Battery Pack Coolant Heater A Control Circuit Low

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The hybrid/ev battery pack coolant heater control signal is stuck low - think of a wire touching ground or a dead sensor. The car limits power to protect itself from heat.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 5 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. 1. Clear the code and confirm it returns under the same conditions before replacing anything.
  2. 2. Inspect the hybrid/ev battery pack coolant heater a control connector and wiring for damage, corrosion, water intrusion, or pins pushed back out of the connector body - pay attention to spots where the harness flexes or rubs. Tests: connector pins corroded - high contact resistance
  3. 3. With a scan tool, watch the live hybrid/ev battery pack coolant heater a control reading while wiggling the harness; a reading that jumps or drops out confirms a wiring or connector fault. Tests: connector pins corroded - high contact resistance
  4. 4. Check the hybrid/ev battery pack coolant heater a control power, ground, and signal wiring for opens and shorts per the factory service manual before condemning the part.
  5. 5. If the wiring tests good, replace the hybrid/ev battery pack coolant heater a control sensor or component, then retest.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$230 – $1720
Labor$140 – $900

Repairing the short in the hybrid/ev battery pack coolant heater a control circuit. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0E13 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Coolant and electrical checks are DIY-friendly; internal valve or pump replacement varies by vehicle.

Watch this repair on YouTube

Parts & tools

Cooling system toolkit — what the job actually takes

Torque specs: Thermostat housing bolts: typically 8–12 Nm. Aluminum threads strip easily — verify spec and use a torque wrench.

Pro tip: Bleed the cooling system per the factory procedure after refilling, or trapped air will overheat the engine and fake a “still broken” reading.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →