Diagnose soonExpect reduced power or limp mode — the hybrid system protects itself by limiting the electric side. Drive gently to a shop and skip long trips.
Think of this code as the battery's computer raising its hand and asking for the check-engine light — it doesn't say what's wrong by itself. The other hybrid codes stored alongside it tell the real story, so pull every code before you touch anything. And since the high-voltage battery is involved, keep your hands off the pack.
Key facts
P0AC4 means hybrid/EV powertrain control module requested MIL illumination. Think of this code as the battery's computer raising its hand and asking for the check-engine light — it doesn't say what's wrong by itself. The other hybrid codes stored alongside it tell the real story, so pull every code before you touch anything. And since the high-voltage battery is involved, keep your hands off the pack. WrenchFair's published fair-price range for this repair is $50–$100 parts and $75–$450 labor at independent shops.
WrenchFair rates P0AC4 a 3-of-5 DIY difficulty (“Middle of the road: visual checks, connectors, fuses, and 12V tests are DIY-friendly, but anything on the high-voltage side belongs to a technician.”) with a “Diagnose soon” driveability rating: Expect reduced power or limp mode — the hybrid system protects itself by limiting the electric side. Drive gently to a shop and skip long trips. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2008–2009 Chevrolet Tahoe Hybrid (6.0L V8) — Auxiliary transmission fluid pump (bump/jerk):Factory-documented
The auxiliary pump and its control module live inside the transmission area; connectors sit just under the 12V battery. A DIY-capable owner with a hybrid-aware scan tool can check for the pump codes and clean the connectors, but pump-module replacement is dealer/trim-shop territory.
Do this test first: Start with high-voltage safety: the traction battery and its orange cables carry voltage high enough to kill. Never open the pack or probe HV connectors yourself — DIY on this code means the 12V system, fuses, and accessible low-voltage connectors only.
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0AC4 on the 2008–2009 Chevrolet Tahoe Hybrid — but the community-sourced Auxiliary transmission fluid pump (bump/jerk) note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Aux pump control module and harness fasteners: verify — Torque specs for the pump module and harness fasteners not confirmed from a forum source — confirm against factory service info before torquing.
Tips
Know the signature symptom: a bump or jerk as the truck switches between electric and engine modes, sometimes with pauses in acceleration or sudden lurches at low speed. It is caused by a hydraulic pressure drop, not by worn gears.
Scan first: the matching codes are P2797 (auxiliary transmission fluid pump performance), P0C2B (pump control module feedback), and P0AC4 (hybrid powertrain control module requested MIL). They point at the aux pump circuit, not at the whole transmission.
Follow the GM preliminary-information bulletin: replace the auxiliary transmission fluid pump control module (GM part 24261817) plus the two harnesses (24259589 and 24259590). One owner reported this as a $637 parts-and-labor fix that held.
Try the cheap DIY step first: an 2009 owner fixed the same fault by unplugging and reseating the pump and module connectors under the battery, which had overheated a pin from high current. A thorough cleaning held for over 15,000 miles. GM revised the module, pump, and plugs for 2010, so 2008–2009 trucks are the affected ones.
If the module swap does not fix it, the next step is the auxiliary pump itself (about $1,200), not a transmission rebuild. Do not let a shop condemn the 2ML70 over this pattern.
Typical difficulty: Moderate — based on 306 code guides for the transmission repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
check engine light on
hybrid system warning message
other hybrid codes stored at the same time
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
downstream fault in hybrid system
communication lag - MIL request stale
an underlying hybrid-system fault stored as a companion code
Owner notes linked to P0AC4: 2 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Start with high-voltage safety: the traction battery and its orange cables carry voltage high enough to kill. Never open the pack or probe HV connectors yourself — DIY on this code means the 12V system, fuses, and accessible low-voltage connectors only. Tests: an underlying hybrid-system fault stored as a companion code
Pull ALL stored codes from every module — this code is just the messenger; the companion hybrid codes are the real diagnosis. Tests: an underlying hybrid-system fault stored as a companion code
Work through the companion codes first, starting with the most severe. Tests: an underlying hybrid-system fault stored as a companion code
Clear codes and retest: if only this one returns with no companions, ask the dealer about a software update for the battery computer. Tests: an underlying hybrid-system fault stored as a companion code
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2008–2009 Chevrolet Tahoe Hybrid: Auxiliary transmission fluid pump (bump/jerk) — test first, then buy for this job.
The price range below is a national planning range for P0AC4 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$50 – $100
Labor$75 – $450
downstream fault in hybrid system. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0AC4 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Middle of the road: visual checks, connectors, fuses, and 12V tests are DIY-friendly, but anything on the high-voltage side belongs to a technician.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →