Diagnose soonThe car will still get you around, but the failed pack stresses the whole hybrid system - get a specialist quote and plan the replacement.
Your hybrid battery has a failed cell - the computer wants the whole pack replaced. The car will still drive, but expect terrible gas mileage and a big bill.
Key facts
P0A80 means replace hybrid battery pack. Your hybrid battery has a failed cell - the computer wants the whole pack replaced. The car will still drive, but expect terrible gas mileage and a big bill. WrenchFair's published fair-price range for this repair is $2000–$8000 parts and $200–$500 labor at independent shops.
WrenchFair rates P0A80 a 5-of-5 DIY difficulty (“DIY diagnosis can confirm it, but pack replacement is specialist work.”) with a “Diagnose soon” driveability rating: The car will still get you around, but the failed pack stresses the whole hybrid system - get a specialist quote and plan the replacement. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2007–2011 Toyota Camry Hybrid (2.4L 2AZ-FXE Hybrid) — Hybrid battery pack replacement:Owner-verified
The 244.8V NiMH pack lives behind the rear seat. Module-level work is high-voltage territory: pull the orange service disconnect, wait for capacitors to discharge, and only proceed if you know HV safety. Buying a used Camry Hybrid is the real DIY angle here — budget for the pack.
Do this test first: Scan all codes - P0A80 with P0A7F or P0AFC may indicate the smart unit or wiring, not the pack.
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0A80 on the 2007–2011 Toyota Camry Hybrid — but the community-sourced Hybrid battery pack replacement note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Hybrid battery pack: verify — No torque specs published — high-voltage service, confirm against factory service info.
Tips
The 2007-2011 NiMH pack is a wear item around the 10-year / 150,000-mile mark. The telltale is the 'Check Hybrid System' light with code P0A80; early signs include the state-of-charge gauge swinging to full unexpectedly and regenerative braking cutting out intermittently.
Pricing owners report: a dealer new pack runs $4,400-$7,000; a rebuilt pack with a 1-3 year warranty runs about $1,500-$2,600 installed; reconditioning services land around $1,500-$2,000. Rebuilders match replacement modules to the remaining good cells — dropping in one random new module next to tired ones is a short-lived fix.
Rule out the cheap stuff first: weak 12V batteries and corroded connections mimic pack failure. One well-documented owner case found every cell healthy and the real fault was corrosion on the pack's copper bus bars — cleaning them (vinegar soak, light scrub, baking-soda neutralization) cleared the warnings for essentially the cost of materials. Treat that as a check step, not a guaranteed fix.
Weak packs can also trigger false VSC/brake warnings, so owners chasing the brake-actuator campaigns are advised to confirm battery health first — the warnings overlap.
Typical difficulty: Involved — based on 854 code guides for the battery repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
hybrid warning light on
terrible fuel economy
engine running constantly
reduced power and sluggish acceleration
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Failed cell blocks in the hybrid battery pack (most common) 2 owner notes link this repair to P0A80
Aging pack with excessive block voltage imbalance
Failed battery smart unit misreading the pack (rule this out first) 2 owner notes link this repair to P0A80
Corroded busbar connections between modules
Damaged wiring to the battery ECU 2 owner notes link this repair to P0A80
Owner notes linked to P0A80: 2 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 6 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Scan all codes - P0A80 with P0A7F or P0AFC may indicate the smart unit or wiring, not the pack. Tests: Failed battery smart unit misreading the pack (rule this out first)
Read hybrid battery block voltages on live data; identify the weak blocks. Tests: Failed cell blocks in the hybrid battery pack (most common)
Look up TSBs for the year, make, and model matching this code.
Test the battery smart unit and harness before condemning the pack. Tests: Failed battery smart unit misreading the pack (rule this out first)
Get quotes for refurbished versus new packs - compare warranty terms, not just price.
Replacement is specialist work: high voltage, proper torque, and system relearning.
Most likely job on your 2007–2011 Toyota Camry Hybrid: Hybrid battery pack replacement — test first, then buy for this job.
The price range below is a national planning range for P0A80 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$2000 – $8000
Labor$200 – $500
Three paths, very different prices: refurbished pack installed by a hybrid specialist or mobile service $1,000-$2,500 (shorter warranty); new OEM pack $2,000-$4,000 plus $200-$500 install labor (2-4 hr swap); dealer-installed new pack typically $3,000-$8,000 all-in. The ranges above show parts vs. install labor separately - match the tier to your situation. Actual quotes vary by vehicle, region, and shop - get a local written estimate. Corrected 2026-10-04 against real-world price evidence (prior labor range mistakenly folded pack price into labor).
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0A80 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
5 of 5 — DIY diagnosis can confirm it, but pack replacement is specialist work.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →