P0996

P0996: Transmission fluid pressure sensor/switch F circuit intermittent

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The pressure sensor for another part of your transmission cuts out randomly - usually a loose or fluid-fouled connector. Expect random harsh or slipping shifts.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Scan all codes and note any that set and clear on their own.
  2. Watch sensor F's live reading while wiggling the transmission harness and connector. Tests: Loose or fluid-fouled sensor F connector (most common)
  3. Pull the connector and inspect for fluid intrusion, corrosion, and spread terminals - clean it thoroughly. Tests: Loose or fluid-fouled sensor F connector (most common)
  4. Check the internal harness where it passes through the case for chafing.
  5. Replace the sensor only if the circuit is proven good and the glitching continues.
  6. Consider a fluid and filter service if the fluid is old - contamination accelerates connector problems.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$80 – $600
Labor$300 – $800

Pressure sensor F connector or wiring repair (sensor replacement if it tests bad). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0996 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Wiggle-testing while watching live data finds these fast.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: Sensor mounting bolts: typically 8–12 Nm — verify spec. Never overtighten sensors with plastic bodies.

Pro tip: Check wiring and connectors first — chafed wires and corroded pins cause more sensor codes than dead sensors do.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →