Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonThe computer defaults to failsafe when it cannot verify relay state - trace the sense wire before driving far.
The feedback wire from your transmission relay is shorted low - the computer cannot see the relay working. Expect failsafe shifting even though the relay may be fine.
Key facts
P0890 means tCM power relay sense circuit low. The feedback wire from your transmission relay is shorted low - the computer cannot see the relay working. Expect failsafe shifting even though the relay may be fine. WrenchFair's published fair-price range for this repair is $20–$300 parts and $120–$400 labor at independent shops.
WrenchFair rates P0890 a 2-of-5 DIY difficulty (“Confirm the relay is actually working first - then the fault must be the sense wire.”) with a “Diagnose soon” driveability rating: The computer defaults to failsafe when it cannot verify relay state - trace the sense wire before driving far. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
transmission stuck in failsafe/limp mode
tcm may actually be powered and communicating
Likely causes
Sense wire shorted to ground (most common)
Corroded connector bridging the sense line to ground
Failed relay (less common here - the sense line is the suspect)
Chafed harness at the relay or fuse box
Failed PCM sense input (rare)
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 6 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Verify actual TCM power with a meter - if the TCM has power, the fault is in the sense wiring, not the relay. Tests: Failed relay (less common here - the sense line is the suspect)
Swap-test the TCM relay anyway; it is cheap.
With power removed, test the sense wire for continuity to ground; repair the shorted section. Tests: Sense wire shorted to ground (most common)
Inspect the relay socket and connectors for corrosion or bridged pins. Tests: Corroded connector bridging the sense line to ground
Trace the sense circuit per the factory wiring diagram.
Suspect the computer's sense input only after wiring is proven good.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$20 – $300
Labor$120 – $400
TCM power relay replacement or sense-circuit short repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0890 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Confirm the relay is actually working first - then the fault must be the sense wire.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →