Diagnose soonMaximum-pressure failsafe shifting bangs the drivetrain - get it diagnosed before it beats up the transmission.
Your transmission's D pressure sensor is reading too low - usually a shorted wire. The computer may overcompensate with harsh, slamming shifts.
Key facts
P0877 means transmission fluid pressure sensor/switch D circuit low. Your transmission's D pressure sensor is reading too low - usually a shorted wire. The computer may overcompensate with harsh, slamming shifts. WrenchFair's published fair-price range for this repair is $80–$350 parts and $200–$500 labor at independent shops.
WrenchFair rates P0877 a 4-of-5 DIY difficulty (“Connector inspection first - the sensor itself is often under the pan.”) with a “Diagnose soon” driveability rating: Maximum-pressure failsafe shifting bangs the drivetrain - get it diagnosed before it beats up the transmission. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2007–2014 Chevrolet Tahoe (5.3L V8, 6.2L V8) — 6L80 P0842/P0872/P0877, 2-3 flare (TEHCM pressure switch laminates):Owner-verified
The TEHCM (valve body with the electronics) lives under the transmission pan. One owner removed the front sway bar, front driveshaft, trans cross member, and exhaust Y-pipe for room, dropped the pan and filter, then pulled the six bolts holding the valve body/TEHCM to do the work on a bench. Six quarts of Dexron VI and a new filter go back in.
Do this test first: Check for TSBs and companion codes; diagnose power faults first.
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0877 on the 2007–2014 Chevrolet Tahoe — but the community-sourced 6L80 P0842/P0872/P0877, 2-3 flare (TEHCM pressure switch laminates) note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Valve body / TEHCM and pan bolts: verify — Valve body and pan torque specs not confirmed from a forum source — confirm against factory service info before torquing.
Tips
These pressure-switch codes are usually the paper-thin laminate membranes under the TEHCM pressure switches, not a dead transmission. A 2007 Yukon Denali owner replaced the four Sonnax laminates at 193k miles and reported no more 2-3 flare and no codes afterward.
A GM transmission specialist on the forum advises testing the pressure switches before buying anything: if the switches do not pass, the TEHCM itself has to be replaced — do not guess.
The repair kit is Sonnax 124740-TL70 (with the tool) or 124740-70K; YouTube walkthroughs cover the valve body/TEHCM removal and laminate install.
While the pan is off, replace the filter (GM 24236933) and refill with Dexron VI; several owners found the fluid and filter long overdue and consider the service part of the cure.
Slow Drive/Reverse engagement after a fluid-and-filter service can also be clutch-adapt relearn, not a failed unit — one owner was told the 'fast learn' relearn is needed after pan work, which a dealer scanner or high-end scan tool runs.
Typical difficulty: Moderate — based on 306 code guides for the transmission repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
harsh, slamming shifts
limp mode
check-engine light on
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Signal wire shorted to ground (most common)
Failed pressure sensor/switch D stuck low
Corroded connector bridging the signal to ground
Chafed harness at the transmission case
Failed PCM/TCM (rare)
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 6 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check for TSBs and companion codes; diagnose power faults first.
Check fluid level and condition.
Inspect the sensor connector and transmission harness for chafing, corrosion, and pin damage. Tests: Chafed harness at the transmission case
Disconnect the sensor and see if the low signal clears - if it does, the sensor is the short.
With power removed, test the signal wire for continuity to ground; repair the shorted section.
Clear the code and confirm the pressure reading responds normally on live data.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2007–2014 Chevrolet Tahoe: 6L80 P0842/P0872/P0877, 2-3 flare (TEHCM pressure switch laminates) — test first, then buy for this job.
The price range below is a national planning range for P0877 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$80 – $350
Labor$200 – $500
Transmission fluid pressure sensor/switch replacement or shorted-wiring repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0877 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — Connector inspection first - the sensor itself is often under the pan.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →