Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Drive safeBackup-light trouble, not a drivability problem - but fix it before a dark parking lot makes the point.
The computer knows you are in reverse, but the signal is not reaching your backup lights. Same dead-or-stuck-on backup light symptoms as P0812, different half of the circuit.
Key facts
P0813 means reverse output circuit. The computer knows you are in reverse, but the signal is not reaching your backup lights. Same dead-or-stuck-on backup light symptoms as P0812, different half of the circuit. WrenchFair's published fair-price range for this repair is $40–$200 parts and $100–$250 labor at independent shops.
WrenchFair rates P0813 a 2-of-5 DIY difficulty (“Work from the lights backward toward the computer - most faults are in the sensor, its wiring, or a connector.”) with a “Drive safe” driveability rating: Backup-light trouble, not a drivability problem - but fix it before a dark parking lot makes the point. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
reverse lights do not work
reverse lights stuck on all the time
no symptoms besides the check-engine light
Likely causes
Failed reverse position sensor or neutral safety switch (most common)
Shorted or open wiring in the reverse output circuit
Corroded connector at the sensor, computer, or lamp assembly
Failed output driver in the PCM (rare)
Programming error (rare)
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 6 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check reverse light behavior and the reverse input reading on the scan tool - if the input reads correctly, the fault is on the output side. Tests: Shorted or open wiring in the reverse output circuit
Look up TSBs for the year, make, and model matching this code.
Test voltage, ground, and signal at the reverse sensor/switch, then at the lamp assemblies. Tests: Failed reverse position sensor or neutral safety switch (most common)
Trace the output circuit from the computer to the lights, checking for opens, shorts, and corroded connectors. Tests: Shorted or open wiring in the reverse output circuit
Test the sensor/switch itself; replace it if it fails factory specs.
Clear the code and verify the lights and scan-tool reverse output agree in every shifter position.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$40 – $200
Labor$100 – $250
Reverse position sensor replacement or output-circuit wiring repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0813 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Work from the lights backward toward the computer - most faults are in the sensor, its wiring, or a connector.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →