P0808

P0808: Clutch position sensor A circuit high

DIY difficulty 2/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The clutch pedal switch is sending a voltage that is too high - usually a wire shorted to power or a bad ground. The scary version: the car may crank and start even with the clutch out.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Look up TSBs for the year, make, and model matching this code.
  2. Test this first: with the car in neutral and parking brake set, see whether the engine cranks without the clutch pressed - that confirms the safety risk.
  3. Inspect the harness for chafing where the signal wire could contact a 12V feed, and check connector pins for bridging. Tests: Damaged connector with pins bridged to a power wire
  4. Test the sensor ground for continuity - an open ground drives the signal high. Tests: Open or corroded ground in the sensor circuit
  5. Disconnect the sensor and see if the high signal drops; if so, replace the sensor.
  6. Clear the code and verify the starter only cranks with the clutch fully pressed.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$25 – $120
Labor$80 – $200

Clutch position sensor replacement or wiring short repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0808 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — Same under-dash circuit as P0807 - trace the short with a multimeter and the factory wiring diagram.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: Sensor mounting bolts: typically 8–12 Nm — verify spec. Never overtighten sensors with plastic bodies.

Pro tip: Check wiring and connectors first — chafed wires and corroded pins cause more sensor codes than dead sensors do.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →