P0806

P0806: Clutch position sensor A circuit range/performance

DIY difficulty 2/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

Your clutch pedal switch works electrically, but the reading it sends does not add up. Expect starting quirks - like needing to pump the pedal - or the check-engine light with no obvious problem.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Look up TSBs for the year, make, and model matching this code.
  2. Use scan-tool live data to watch the clutch position sensor state while slowly pressing and releasing the pedal - look for flickering or a dead zone. Tests: Clutch position sensor out of adjustment or misaligned on the pedal bracket (most common)
  3. Check the switch adjustment and mounting on the pedal bracket; reposition per factory spec if it is out of alignment. Tests: Clutch position sensor out of adjustment or misaligned on the pedal bracket (most common)
  4. Inspect connectors and wiring for corrosion or partial damage that could skew the signal. Tests: Damaged wiring with partial chafing or intermittent contact
  5. Test the sensor's signal output against factory specifications; replace the sensor if the signal is erratic or out of range.
  6. Clear the code, verify clean on/off switching through the full pedal travel, and confirm normal starting.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$25 – $120
Labor$80 – $180

Clutch position sensor adjustment or replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0806 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — Often fixed by adjusting or replacing the pedal switch - both are under-dash jobs a DIYer can handle.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: Sensor mounting bolts: typically 8–12 Nm — verify spec. Never overtighten sensors with plastic bodies.

Pro tip: Check wiring and connectors first — chafed wires and corroded pins cause more sensor codes than dead sensors do.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →