Diagnose soonTransmission may shift poorly. Drive gently and diagnose soon.
A third pressure-regulating solenoid is stuck or weak. Like the others, this means slipping or harsh shifts from wrong clutch pressure.
Model notes: Multiple pressure control codes together suggest fluid contamination or a failing pump rather than three simultaneous solenoid failures - look for the common cause.
Key facts
P0796 means pressure control solenoid C performance/stuck off. A third pressure-regulating solenoid is stuck or weak. Like the others, this means slipping or harsh shifts from wrong clutch pressure. WrenchFair's published fair-price range for this repair is $50–$200 parts and $200–$600 labor at independent shops.
WrenchFair rates P0796 a 4-of-5 DIY difficulty (“Same diagnostic family as the other pressure control codes.”) with a “Diagnose soon” driveability rating: Transmission may shift poorly. Drive gently and diagnose soon. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2007–2014 Cadillac Escalade (6.2L V8 (L92/L94)) — 6L80 torque converter clutch (TCC) shudder and harsh engagement:Owner-verified
The GM fix path is a torque converter replacement (plus full flush) or a complete rebuild/used 6L80 - the 6L80 is a common DIY-puller but a specialist rebuild. GM reman 6L80s carry a 3 yr/100k warranty and need no programming. A converter-only swap on a contaminated unit is a documented comeback risk.
Do this test first: Check fluid condition first
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0796 on the 2007–2014 Cadillac Escalade — but the community-sourced 6L80 torque converter clutch (TCC) shudder and harsh engagement note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Tips
A rumble-strip shudder under light throttle at cruising speed (often 40-70 mph) with no harsh shift yet is the early signature of TCC slip. Scan for P0756, P0796, P2714, P2723 in the TCM - GM's own PI ties these codes to TCC shudder/harsh engagement on the 2008 Escalade.
Drop the pan before deciding: black fluid with metal shavings on the magnet means the converter has been shedding debris through the unit. Owners report the transmission can still shift fine at this stage, which makes the shudder easy to ignore until it isn't.
The converter clutch is the documented weak point of the 6L80 family - its thin stock clutch sheds material, and that debris takes out the pump, valve body, and clutch packs. That is why transmission shops warn that a converter-only swap on a contaminated unit rarely lasts.
If you DIY a rebuild, plan on a new or upgraded torque converter (not the stock-spec one), a full seal/friction refresh, and the updated TCC regulator valves - skipping the converter is the classic comeback.
Budget reality from owner threads: a professional rebuild with an upgraded converter runs well into four figures; a GM reman with a 3 yr/100k mile warranty is the low-drama alternative and needs no relearn.
Typical difficulty: Moderate — based on 306 code guides for the transmission repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
slipping or harsh shifts
check engine light
limp mode
transmission overheating
worse fuel economy
misfire-like stumble
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Sticking solenoid C (most common)
Contaminated fluid
Valve body wear
Circuit electrical fault
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check fluid condition first
Test solenoid electrically and functionally with scan-tool commands Tests: Sticking solenoid C (most common)
Verify with a line pressure gauge where a test port exists
Replace the solenoid; investigate valve body wear if pressure still won't regulate Tests: Valve body wear
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2007–2014 Cadillac Escalade: 6L80 torque converter clutch (TCC) shudder and harsh engagement — test first, then buy for this job.
The price range below is a national planning range for P0796 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$50 – $200
Labor$200 – $600
Solenoid replacement; pan-accessible on many transmissions. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0796 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — Same diagnostic family as the other pressure control codes.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →