P0796

P0796 on a 2007–2014 Cadillac Escalade: Pressure control solenoid C performance/stuck off

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: P0796 on a 2007–2014 Cadillac Escalade

DIY difficulty 4/5

A third pressure-regulating solenoid is stuck or weak. Like the others, this means slipping or harsh shifts from wrong clutch pressure.

Model notes: Multiple pressure control codes together suggest fluid contamination or a failing pump rather than three simultaneous solenoid failures - look for the common cause.

Key facts

☑ Before you buy parts — check these first:
On your 2007–2014 Cadillac Escalade (6.2L V8 (L92/L94)) — 6L80 torque converter clutch (TCC) shudder and harsh engagement: Owner-verified
The GM fix path is a torque converter replacement (plus full flush) or a complete rebuild/used 6L80 - the 6L80 is a common DIY-puller but a specialist rebuild. GM reman 6L80s carry a 3 yr/100k warranty and need no programming. A converter-only swap on a contaminated unit is a documented comeback risk.
Do this test first: Check fluid condition first
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0796 on the 2007–2014 Cadillac Escalade — but the community-sourced 6L80 torque converter clutch (TCC) shudder and harsh engagement note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Tips

Sources: GM preliminary information (PIP4292, via gm.saturn.team): DTC P0756, P0796, P2714, P2723 / TCC shudder or harsh engagement on 2008 Escalade with 6L50/6L80/6L90 · Tahoe Yukon Forum: GM 6L80 transmission information thread (owner shudder reports, converter failure discussion) · Tahoe Yukon Forum: 6L80 transmission rebuild thread (2015 Tahoe torque converter failure - shudder under low load, black fluid, metal in pan) · YouTube teardown: why replacing just the torque converter on a 6L80 is a comeback (converter debris contaminates the whole unit)

Typical difficulty: Moderate — based on 306 code guides for the transmission repair area (an area-level estimate, not this exact job).

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check fluid condition first
  2. Test solenoid electrically and functionally with scan-tool commands Tests: Sticking solenoid C (most common)
  3. Verify with a line pressure gauge where a test port exists
  4. Replace the solenoid; investigate valve body wear if pressure still won't regulate Tests: Valve body wear

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2007–2014 Cadillac Escalade: 6L80 torque converter clutch (TCC) shudder and harsh engagement — test first, then buy for this job.
The price range below is a national planning range for P0796 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$50 – $200
Labor$200 – $600

Solenoid replacement; pan-accessible on many transmissions. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0796 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

4 of 5 — Same diagnostic family as the other pressure control codes.

Watch this repair on YouTube

Parts & tools

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →