Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonWrong pressure wears clutches fast - diagnose promptly.
Your transmission controls clutch pressure with electric solenoids, and solenoid B has an electrical fault - open, short, or wrong resistance. Wrong pressure means harsh shifts, slipping, or limp mode. Check the fluid level first, then test the solenoid.
Key facts
P0778 means pressure Control Solenoid B Electrical. Your transmission controls clutch pressure with electric solenoids, and solenoid B has an electrical fault - open, short, or wrong resistance. Wrong pressure means harsh shifts, slipping, or limp mode. Check the fluid level first, then test the solenoid. WrenchFair's published fair-price range for this repair is $80–$600 parts and $200–$600 labor at independent shops.
WrenchFair rates P0778 a 3-of-5 DIY difficulty (“The solenoids are inside the pan on the valve body.”) with a “Diagnose soon” driveability rating: Wrong pressure wears clutches fast - diagnose promptly. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
harsh shifts
slipping
limp mode
check engine light on
Likely causes
failed pressure control solenoid B
low or contaminated fluid
wiring fault to the solenoid
valve body fault
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check the fluid level and condition.
Scan for all codes and record freeze-frame data, then clear the code and test-drive to see if it returns.
Test solenoid B's resistance and compare with spec. Tests: failed pressure control solenoid B
Inspect the wiring to the solenoid. Tests: wiring fault to the solenoid
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$80 – $600
Labor$200 – $600
Pressure control solenoid B replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0778 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — The solenoids are inside the pan on the valve body.
Torque specs: Pan bolts: typically 8–12 Nm in a crisscross pattern — verify spec. Over-tightening warps the pan and causes leaks.
Pro tip: Use ONLY the fluid your transmission calls for (e.g. ZF Lifeguard 8 for ZF 8-speeds) — wrong fluid kills transmissions. Measure what came out.
As an Amazon Associate, WrenchFair earns from qualifying purchases.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →