Diagnose soonWrong pressure wears clutches fast - diagnose promptly.
Your transmission controls clutch pressure with electric solenoids, and solenoid B is stuck on, holding pressure high. Wrong pressure means harsh shifts, slipping, or limp mode. Check the fluid level first, then test the solenoid.
Key facts
P0777 means pressure Control Solenoid B Stuck On. Your transmission controls clutch pressure with electric solenoids, and solenoid B is stuck on, holding pressure high. Wrong pressure means harsh shifts, slipping, or limp mode. Check the fluid level first, then test the solenoid. WrenchFair's published fair-price range for this repair is $80–$600 parts and $200–$600 labor at independent shops.
WrenchFair rates P0777 a 3-of-5 DIY difficulty (“The solenoids are inside the pan on the valve body.”) with a “Diagnose soon” driveability rating: Wrong pressure wears clutches fast - diagnose promptly. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2007–2009 GMC Acadia (3.6L V6) — 3-5-R wave plate failure (no reverse, 3rd/5th flare):Owner-verified
Transmission-out job — the 3-5-R clutch wave plate lives inside the 6T70/6T75 case. Diagnosis is the DIY-friendly part; the repair is a transmission rebuild or replacement best left to a specialist.
Do this test first: Check the fluid level and condition.
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0777 on the 2007–2009 GMC Acadia — but the community-sourced 3-5-R wave plate failure (no reverse, 3rd/5th flare) note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Transmission internal fasteners: verify — Specialist rebuild — no owner-documented torque specs; confirm against factory service info.
Tips
Learn the pattern: SES light plus no reverse, and/or a slip/flare or harsh shift in 3rd and 5th gears. The classic DTC is P0776 (clutch pressure control solenoid 2 stuck off); P0777, P2723, P0717, P0716, P2715, and P2714 can set from the same failure.
The cause per GM bulletin 09-07-30-012B is a broken 3-5-R (35R) clutch wave plate that lets the apply piston over-stroke and leak — typically not before about 20,000 miles. Debris from the breakage can also foul the speed sensors and other clutches.
The documented fix is the updated waved clutch plate (P/N 24254103) with a full cleanup: debris cleaned from the whole transmission, plus a new pump fluid filter and control-solenoid filter plate. Skipping the cleanup is how repeat failures happen.
One owner caught it early and had a dealer rebuild for under $1,500 with GM assistance — so stop driving it the moment reverse disappears or 3rd/5th starts flaring, and call a dealer about goodwill help before authorizing a $4,000-$5,000 replacement.
If a shop does the rebuild, the plate's installation orientation matters (GM guidance: rounded edge of the internal splines toward the 35R piston) to prevent a repeat failure.
A full replacement transmission is the common outcome once debris has circulated — multiple owners report reman units after the wave plate disintegrated, so early diagnosis genuinely saves money here.
Typical difficulty: Moderate — based on 306 code guides for the transmission repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
harsh shifts
slipping
limp mode
check engine light on
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
failed pressure control solenoid B
low or contaminated fluid
wiring fault to the solenoid
valve body fault
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check the fluid level and condition.
Scan for all codes and record freeze-frame data, then clear the code and test-drive to see if it returns.
Test solenoid B's resistance and compare with spec. Tests: failed pressure control solenoid B
Inspect the wiring to the solenoid. Tests: wiring fault to the solenoid
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2007–2009 GMC Acadia: 3-5-R wave plate failure (no reverse, 3rd/5th flare) — test first, then buy for this job.
The price range below is a national planning range for P0777 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$80 – $600
Labor$200 – $600
Pressure control solenoid B replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0777 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — The solenoids are inside the pan on the valve body.
Torque specs: Pan bolts: typically 8–12 Nm in a crisscross pattern — verify spec. Over-tightening warps the pan and causes leaks.
Pro tip: Use ONLY the fluid your transmission calls for (e.g. ZF Lifeguard 8 for ZF 8-speeds) — wrong fluid kills transmissions. Measure what came out.
As an Amazon Associate, WrenchFair earns from qualifying purchases.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →