Diagnose soonA bad sensor reading can cause poor running or stalling. Drive carefully and diagnose soon.
The sensor reporting the transmission's output speed has an electrical fault. Expect wrong shift timing, harsh shifts, or limp mode.
Model notes: On some vehicles the output speed sensor also feeds the speedometer - a dead speedometer plus shifting complaints points straight here.
Key facts
P0720 means output speed sensor circuit malfunction. The sensor reporting the transmission's output speed has an electrical fault. Expect wrong shift timing, harsh shifts, or limp mode. WrenchFair's published fair-price range for this repair is $30–$120 parts and $80–$200 labor at independent shops.
WrenchFair rates P0720 a 2-of-5 DIY difficulty (“Output sensors are usually external and accessible - one of the easier transmission repairs.”) with a “Diagnose soon” driveability rating: A bad sensor reading can cause poor running or stalling. Drive carefully and diagnose soon. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2014–2015 Infiniti Q50 (3.7L VQ37VHR V6 (non-hybrid)) — P0720 output speed sensor code: replace the control valve, not the sensor (TSB ITB19-040):Owner-verified
Driveway-diagnosable: a P0720 on a 2014-2015 Q50 with harsh shifts or limp mode points at the valve body, not the sensor. The fix is pan-drop valve-body/TCM replacement — a transmission-shop job for most, but knowing the bulletin saves owners from a wasted sensor replacement first.
Do this test first: Watch the output speed PID on a test drive - dropouts or zero confirm the fault
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0720 on the 2014–2015 Infiniti Q50 — but the community-sourced P0720 output speed sensor code: replace the control valve, not the sensor (TSB ITB19-040) note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Control valve / valve body fasteners (see factory ESM torque specs): verify — Not published in the TSB; confirm in the 2014-2015 Q50 service manual before reassembly.
Tips
TSB ITB19-040 (AT19-014, Nov 22, 2019) covers 2014-2015 Q50 (V37) with the 7-speed RE7R01A: MIL on with P0720 (output speed sensor), possibly with harsh shifting and/or lack of power.
The money-saving core of the bulletin: if diagnosis points at the output speed sensor, replace the CONTROL VALVE (valve body + TCM assembly) instead. Do not replace the output speed sensor.
This matters because the usual instinct - and the pre-bulletin ESM flow - is to swap the tail-shaft speed sensor, which is buried (tail shaft removal) and does not fix it. The bulletin explicitly overrides that.
DIY value: Mils Garage's video documents a P0720 fixed on a real 2015 Q50 via the valve body route, showing how to access it. A shop quoting just a sensor swap on a 2014-2015 Q50 P0720 is working against the factory bulletin.
Bulletin does not apply to the Q50 Hybrid - gas 3.7L V6 models only.
Typical difficulty: Moderate — based on 306 code guides for the transmission repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
erratic shifting
limp mode
speedometer issues on some vehicles
check engine light
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Failed output speed sensor (most common)
Wiring damage - these run near hot exhaust and moving parts
Corroded connector
Damaged tone ring
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Watch the output speed PID on a test drive - dropouts or zero confirm the fault Tests: Failed output speed sensor (most common)
Inspect the sensor and wiring for physical damage Tests: Wiring damage - these run near hot exhaust and moving parts
Check the tone ring for damage Tests: Damaged tone ring
Replace the sensor if the circuit tests good but produces no signal
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2014–2015 Infiniti Q50: P0720 output speed sensor code: replace the control valve, not the sensor (TSB ITB19-040) — test first, then buy for this job.
The price range below is a national planning range for P0720 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$30 – $120
Labor$80 – $200
Sensor replacement is the typical fix. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0720 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Output sensors are usually external and accessible - one of the easier transmission repairs.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →