Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonVerify fan operation - overheating risk in traffic if the fan is dead.
The control circuit for cooling fan 2 has an electrical fault. Make sure the fan actually spins - overheating in traffic is the real risk - then check the relay, fuse, and wiring.
Key facts
P0694 means fan 2 Control Circuit High. The control circuit for cooling fan 2 has an electrical fault. Make sure the fan actually spins - overheating in traffic is the real risk - then check the relay, fuse, and wiring. WrenchFair's published fair-price range for this repair is $15–$400 parts and $75–$250 labor at independent shops.
WrenchFair rates P0694 a 2-of-5 DIY difficulty (“Relay swap and fan motor test; straightforward.”) with a “Diagnose soon” driveability rating: Verify fan operation - overheating risk in traffic if the fan is dead. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light on
cooling fan not running
engine temperature climbing in traffic
A/C warm at idle
Likely causes
failed fan relay
blown fuse
open or shorted wiring
seized fan motor
corroded connector
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 6 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Scan for all codes and record freeze-frame data, then clear the code and test-drive to see if it returns.
Check the related fuses and relays before condemning any part - an open fuse is a cheap fix.
Verify fan 2 actually runs.
Swap the relay and inspect its socket.
Test the fan motor directly and check the wiring.
Suspect the PCM only after every wire and component test passes - module failure is rare.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$15 – $400
Labor$75 – $250
Cooling fan relay or motor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0694 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Relay swap and fan motor test; straightforward.
Torque specs: Thermostat housing bolts: typically 8–12 Nm. Aluminum threads strip easily — verify spec and use a torque wrench.
Pro tip: Bleed the cooling system per the factory procedure after refilling, or trapped air will overheat the engine and fake a “still broken” reading.
As an Amazon Associate, WrenchFair earns from qualifying purchases.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →