Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonStalling risk - diagnose promptly.
Your fuel pump is run by an electronic module rather than a simple relay, and that module has a fault. Check its power, ground, and wiring first - modules are pricey.
Key facts
P064A means fuel Pump Control Module A. Your fuel pump is run by an electronic module rather than a simple relay, and that module has a fault. Check its power, ground, and wiring first - modules are pricey. WrenchFair's published fair-price range for this repair is $100–$500 parts and $100–$300 labor at independent shops.
WrenchFair rates P064A a 3-of-5 DIY difficulty (“Module power/ground testing; the module is often under the rear seat or in the trunk.”) with a “Diagnose soon” driveability rating: Stalling risk - diagnose promptly. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
hard starting
stalling
no-start
check engine light on
Likely causes
failed fuel pump control module
bad power or ground to the module
wiring fault
corroded connector
failed fuel pump overloading the module
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Scan for all codes and record freeze-frame data, then clear the code and test-drive to see if it returns.
Check power and ground at the module connector. Tests: bad power or ground to the module
Verify the fuel pump itself is not shorted and overloading the module. Tests: failed fuel pump overloading the module
Replace the module only after its feeds test good.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$100 – $500
Labor$100 – $300
Fuel pump control module replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P064A ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Module power/ground testing; the module is often under the rear seat or in the trunk.
Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.
As an Amazon Associate, WrenchFair earns from qualifying purchases.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →