Diagnose soonA charging fault will strand you when the battery dies - diagnose soon.
The wire your car's computer uses to control the alternator's output is shorted low, so the alternator cannot charge right. Check the wiring to the alternator, then the alternator itself.
Key facts
P0625 means generator Field/F Terminal Circuit Low. The wire your car's computer uses to control the alternator's output is shorted low, so the alternator cannot charge right. Check the wiring to the alternator, then the alternator itself. WrenchFair's published fair-price range for this repair is $20–$500 parts and $75–$300 labor at independent shops.
WrenchFair rates P0625 a 2-of-5 DIY difficulty (“Charging system testing with a multimeter; check wiring first.”) with a “Diagnose soon” driveability rating: A charging fault will strand you when the battery dies - diagnose soon. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Service bulletins: 610 factory bulletins on file for this vehicle (mostly Equipment, Electrical System, Structure) — see the latest ones
On your 2018–2024 Toyota Camry (2.5L 4-cyl (A25A-FKS)) — Alternator replacement:Owner-verified
The 2.5L A25A-FKS alternator is removed from the TOP of the engine bay — no wheel-well or undertray access needed. Disconnect the negative battery cable first (10 mm clamp bolt) to prevent shorts on the charging circuit. Remove the plastic cover over the alternator positive stud, pull the 10 mm nut off the stud, and unplug the field connector (press the lock tab; grip only the plastic connector). Photograph the serpentine belt routing, then rotate the tensioner counter-clockwise with a 14 mm wrench and slip the belt off the alternator pulley. Remove the 10 mm bolt holding the engine wire-harness bracket, then the upper 12 mm mounting bolt and the two 12 mm lower mounting nuts; pull the alternator straight rearward off the studs and lift it upward out of the engine compartment. Caution: the charging-terminal stud passes through an insulating bushing — when reinstalling, tighten the 10 mm terminal nut only until snug.
Do this test first: Scan for all codes and record freeze-frame data, then clear the code and test-drive to see if it returns.
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0625 on the 2018–2024 Toyota Camry — but the community-sourced Alternator replacement note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Alternator mounting bolts/nuts: verify — Upper 12 mm bolt + two 12 mm lower stud nuts per iFixit 2018-2024 Camry guide; torque not stated — confirm against factory service info for this engine.
Charging-terminal stud nut: verify — 10 mm nut; iFixit notes it must be only snug (stud passes through an insulating bushing).
Tips
Take a clear photo of the belt routing around all pulleys before removing the belt — reassembly depends on it (iFixit guide).
Release the tensioner slowly to avoid injury and damage to the tensioner assembly (iFixit guide).
Disconnect the negative battery cable first and keep it from contacting the terminal while working; never disconnect electrical connections with the engine running.
Grip only the plastic connector bodies when unplugging the alternator connector — never pull on the wires.
Check belt condition and verify it sits fully in every pulley groove before releasing the tensioner.
Typical difficulty: Involved — based on 854 code guides for the battery repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
battery warning light on or not working
battery going dead
check engine light on
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
short to ground in the field wiring
failed alternator 3 owner notes link this repair to P0625
damaged connector
wiring chafed against the engine
Owner notes linked to P0625: 3 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Scan for all codes and record freeze-frame data, then clear the code and test-drive to see if it returns.
Measure battery voltage engine off and running - running voltage should be higher and steady.
Inspect the wiring between the computer and the alternator. Tests: failed alternator
Have the alternator and battery load-tested. Tests: failed alternator
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2018–2024 Toyota Camry: Alternator replacement — test first, then buy for this job.
The price range below is a national planning range for P0625 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$20 – $500
Labor$75 – $300
Alternator replacement or wiring repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0625 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Charging system testing with a multimeter; check wiring first.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →