Diagnose soonVerify real oil pressure before driving far - a lying sensor is common, but real pressure loss is engine-ending.
The sensor watching your oil pressure is giving a bad electrical signal. Do not just assume the sensor is lying - check the oil level and have the pressure verified with a mechanical gauge, because real oil pressure loss wrecks engines fast. If pressure is truly fine, it is the sensor or its wiring.
Key facts
P0520 means engine Oil Pressure Sensor/Switch Circuit. The sensor watching your oil pressure is giving a bad electrical signal. Do not just assume the sensor is lying - check the oil level and have the pressure verified with a mechanical gauge, because real oil pressure loss wrecks engines fast. If pressure is truly fine, it is the sensor or its wiring. WrenchFair's published fair-price range for this repair is $30–$120 parts and $75–$200 labor at independent shops.
WrenchFair rates P0520 a 2-of-5 DIY difficulty (“Sensor swap is easy; the critical step is verifying real pressure with a gauge.”) with a “Diagnose soon” driveability rating: Verify real oil pressure before driving far - a lying sensor is common, but real pressure loss is engine-ending. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Service bulletins: 384 factory bulletins on file for this vehicle (mostly Equipment, Electrical System, Structure) — see the latest ones
On your 2016–2022 Lexus RX (3.5L V6 (2GR-FKS)) — Oil & filter change:Owner-verified
Drain plug is a 14 mm on the oil pan; the RX sits low, so owners recommend ramps or jack stands, and the filter/drain access is behind a small splash-shield service flap with plastic clips. The filter is a paper cartridge inside a plastic canister housing (not a spin-on) — you need the proper 64 mm cap-style wrench. Fill is roughly 5.7 quarts of 0W-20 synthetic, and owners report 10k-mile dealer intervals but most DIYers change it sooner on their own.
Do this test first: Check the oil level first - top up if low.
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0520 on the 2016–2022 Lexus RX — but the community-sourced Oil & filter change note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Oil drain plug: verify — Confirm against factory service info for the 2GR-FKS before torquing — always use a fresh crush washer.
Filter housing cap: verify — Confirm against factory service info for the 2GR-FKS before torquing — overtightening cracks the plastic housing.
Tips
Get the proper cap-style filter wrench (e.g., the MotivX-style tool) — a strap wrench will not fit, and dealers universally overtighten the housing, making the first DIY removal a fight.
The plastic housing can crack if over-torqued; several owners hand-tighten to the hard stop with a lubed O-ring and have zero leaks.
The small center drain plug on the housing needs very little torque — it snaps easily if over-torqued.
Oil the new large O-ring with fresh oil and seat it in the correct groove; a wrong groove leaks.
Keep the splash-shield clips in a cup — they're easy to lose and rattle without them.
Typical difficulty: Moderate — based on 5 code guides for the oil repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
oil pressure warning light or gauge acting up
check engine light on
ticking from low oil (if real)
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
failed oil pressure sensor
wiring fault in the sensor circuit
low oil level
corroded connector
actually low oil pressure (verify!)
Owner notes linked to P0520: 6 across 2 repairs — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check the oil level first - top up if low.
Scan for all codes and record freeze-frame data, then clear the code and test-drive to see if it returns.
Verify actual oil pressure with a mechanical gauge at the sensor port. Tests: failed oil pressure sensor
If pressure is normal, test the sensor circuit and replace the sensor. Tests: failed oil pressure sensor
If pressure is truly low, stop and diagnose the oiling system - do not drive.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2016–2022 Lexus RX: Oil & filter change — test first, then buy for this job.
The price range below is a national planning range for P0520 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$30 – $120
Labor$75 – $200
Oil pressure sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0520 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Sensor swap is easy; the critical step is verifying real pressure with a gauge.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →