Diagnose soonVerify real oil pressure before driving far - a lying sensor is common, but real pressure loss is engine-ending.
The sensor watching your oil pressure is giving a bad electrical signal. Do not just assume the sensor is lying - check the oil level and have the pressure verified with a mechanical gauge, because real oil pressure loss wrecks engines fast. If pressure is truly fine, it is the sensor or its wiring.
Key facts
P0520 means engine Oil Pressure Sensor/Switch Circuit. The sensor watching your oil pressure is giving a bad electrical signal. Do not just assume the sensor is lying - check the oil level and have the pressure verified with a mechanical gauge, because real oil pressure loss wrecks engines fast. If pressure is truly fine, it is the sensor or its wiring. WrenchFair's published fair-price range for this repair is $30–$120 parts and $75–$200 labor at independent shops.
WrenchFair rates P0520 a 2-of-5 DIY difficulty (“Sensor swap is easy; the critical step is verifying real pressure with a gauge.”) with a “Diagnose soon” driveability rating: Verify real oil pressure before driving far - a lying sensor is common, but real pressure loss is engine-ending. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Service bulletins: 1,210 factory bulletins on file for this vehicle (mostly Electrical System, Equipment, Power Train) — see the latest ones
On your 2007–2018 Jeep Wrangler (3.8L V6) — 3.8L oil consumption (management):Owner-verified
No disassembly — this note is about living with the 3.8L's appetite. Check the dipstick at every fuel fill-up and carry a quart in the Jeep; many of these engines drink a quart every 1,000 miles, which Chrysler calls within spec.
Do this test first: Check the oil level first - top up if low.
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0520 on the 2007–2018 Jeep Wrangler — but the community-sourced 3.8L oil consumption (management) note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Drain plug and filter cap: verify — No torque-critical fasteners beyond the drain plug in the management routine — confirm the plug spec against factory service info.
Tips
The honest truth first: many 2007–2011 3.8Ls left the Mexican assembly plant with piston rings installed upside down, and the oiling passages sludge easily. There is no cheap permanent fix — treat anyone selling one with skepticism.
The proven owner protocol for years of reliable service: check oil at every fill-up, top off with the same spec oil, and never let it run low. Low oil kills these engines; the consumption itself doesn't if you stay on top of it.
Replace the PCV valve first — it's cheap, takes minutes, and a stuck PCV is the only inexpensive thing that sometimes reduces consumption.
Many owners report 10W-30 slows consumption versus 5W-20. That's a mitigation, not a repair — it doesn't fix the rings.
A leakdown test confirms ring trouble if you want proof before deciding whether to live with it or rebuild.
Typical difficulty: Moderate — based on 5 code guides for the oil repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
oil pressure warning light or gauge acting up
check engine light on
ticking from low oil (if real)
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
failed oil pressure sensor
wiring fault in the sensor circuit
low oil level
corroded connector
actually low oil pressure (verify!)
Owner notes linked to P0520: 6 across 2 repairs — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check the oil level first - top up if low.
Scan for all codes and record freeze-frame data, then clear the code and test-drive to see if it returns.
Verify actual oil pressure with a mechanical gauge at the sensor port. Tests: failed oil pressure sensor
If pressure is normal, test the sensor circuit and replace the sensor. Tests: failed oil pressure sensor
If pressure is truly low, stop and diagnose the oiling system - do not drive.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2007–2018 Jeep Wrangler: 3.8L oil consumption (management) — test first, then buy for this job.
The price range below is a national planning range for P0520 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$30 – $120
Labor$75 – $200
Oil pressure sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0520 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Sensor swap is easy; the critical step is verifying real pressure with a gauge.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →