Drive safeSafe to drive. Fix at your convenience - high idle wastes fuel but won't damage anything quickly.
Your car is idling too fast. Usually a vacuum leak or a bad PCV valve - annoying and bad for gas mileage, but not an emergency.
Model notes: If P0507 appears with lean codes, chase the vacuum leak first - fixing it usually resolves both. Also check the throttle body for carbon holding the plate open.
Key facts
P0507 means idle air control system RPM higher than expected. Your car is idling too fast. Usually a vacuum leak or a bad PCV valve - annoying and bad for gas mileage, but not an emergency. WrenchFair's published fair-price range for this repair is $20–$150 parts and $100–$250 labor at independent shops.
WrenchFair rates P0507 a 2-of-5 DIY difficulty (“Diagnosis is quick; repair difficulty follows whatever is leaking.”) with a “Drive safe” driveability rating: Safe to drive. Fix at your convenience - high idle wastes fuel but won't damage anything quickly. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Service bulletins: 610 factory bulletins on file for this vehicle (mostly Equipment, Electrical System, Structure) — see the latest ones
On your 2018–2024 Toyota Camry (2.5L 4-cyl (A25A-FKS)) — Throttle body cleaning:Owner-verified
The A25A-FKS uses a drive-by-wire electronic throttle body mounted on the intake manifold. Remove the plastic engine cover, then loosen the clamp on the intake air hose at the air cleaner outlet and move the hose aside to expose the throttle body — no removal from the manifold is needed to clean it. Spray throttle body cleaner and wipe the bore and both sides of the plate with a soft cloth or brush; if you open the plate, move it VERY slowly — if you hear the internal motor, you are moving too fast. If you do remove the throttle body from the manifold, install a new gasket; reusing the old one risks vacuum leaks. Keep the removed unit upright and do not flood the motor/gear housing with solvent.
Do this test first: Same tests as P2187: oil-cap suction test, listen for whistle, smoke test
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0507 on the 2018–2024 Toyota Camry — but the community-sourced Throttle body cleaning note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Throttle body mounting bolts: verify — Confirm against factory service info before torquing.
Tips
High idle after cleaning is the classic symptom on Toyotas: carbon was restricting airflow and the ECM had adapted, so it briefly over-fuels clean air. It resolves after the idle relearn.
Idle relearn for Toyota electronic throttle: disconnect the negative battery cable for at least 60 seconds to clear keep-alive memory, reconnect, turn the ignition ON without touching the accelerator, then start the engine. A ~10-minute disconnect also works per owner reports; otherwise the ECM relearns over several drive cycles.
On a 2020–2022 Camry A25A-FKS, cold-weather limp mode with P01201C, P210015, P210019, or P211172 is a known issue: Toyota T-SB-0005-24 directs dealers to perform an ECM calibration reflash and replace the fuel pump — that fix is not DIY, so reference the TSB number at the dealer instead of buying a throttle body.
Clean the MAF sensor with dedicated MAF cleaner while the intake hose is off — do not touch or scrub its wires, and let it dry before reconnecting.
Typical difficulty: Moderate — based on 307 code guides for the intake repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
high idle
rough idle
check engine light
whistling
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Failed PCV diaphragm 3 owner notes link this repair to P0507
Vacuum leak downstream of throttle 12 owner notes link this repair to P0507
Carbon-fouled throttle body 12 owner notes link this repair to P0507
Faulty idle control adaptation (re-adapt after repair) 12 owner notes link this repair to P0507
Owner notes linked to P0507: 15 across 2 repairs — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 3 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Same tests as P2187: oil-cap suction test, listen for whistle, smoke test
Check throttle body for carbon holding the plate open Tests: Carbon-fouled throttle body
Verify no one adjusted the throttle stop screw Tests: Vacuum leak downstream of throttle
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2018–2024 Toyota Camry: Throttle body cleaning — test first, then buy for this job.
The price range below is a national planning range for P0507 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$20 – $150
Labor$100 – $250
PCV valve or hose replacement is the typical fix. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0507 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Diagnosis is quick; repair difficulty follows whatever is leaking.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →