Drive safeEmissions-only fault. Safe to drive - fix at your convenience (often just the gas cap).
The system that burns off stored gas fumes isn't flowing - usually a clogged or stuck-shut valve. The car runs fine; it's an emissions issue.
Model notes: Chronic 'topping off' the tank after the pump clicks floods the charcoal canister with liquid fuel - stop at the first click to prevent this whole category of faults.
Key facts
P0497 means evaporative emission system low purge flow. The system that burns off stored gas fumes isn't flowing - usually a clogged or stuck-shut valve. The car runs fine; it's an emissions issue. WrenchFair's published fair-price range for this repair is $15–$80 parts and $0–$180 labor at independent shops.
WrenchFair rates P0497 a 2-of-5 DIY difficulty (“Distinguish a stuck valve from a blocked hose with the blow-through test in both states.”) with a “Drive safe” driveability rating: Emissions-only fault. Safe to drive - fix at your convenience (often just the gas cap). These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2013–2018 Acura RDX (3.5L V6 (J35Z5)) — EVAP purge control solenoid failure (P0441/P0497) - TSB B23-035 for 2018 RDX:Factory-documented
Driveway-friendly: the purge control solenoid valve is under the engine cover - disconnect the connector and hose, swap the valve, clear the code. Confirm VIN eligibility for TSB 23-035 (2018 RDX) first.
Do this test first: Command the purge valve open with a scan tool and check for flow - no flow means valve or hose
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0497 on the 2013–2018 Acura RDX — but the community-sourced EVAP purge control solenoid failure (P0441/P0497) - TSB B23-035 for 2018 RDX note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Tips
A check-emissions light with P0441 (purge flow malfunction) or P0497 (low purge flow) on a 2nd-gen RDX usually means the EVAP purge control solenoid valve is sticking - TSB B23-035 covers the 2018 RDX for P0441 specifically.
Per the bulletin, variations in the valve's spring cause uneven wear and intermittent sticking - a new valve (P/N 36162-5G0-A02 superseding -A01) is the fix, followed by an EVAP function test.
One 2015 RDX owner fixed P0497 plus P145C with a purge valve solenoid replacement for about $70 - it's a 30-minute job under the engine cover, not a dealer-only repair.
Don't confuse the purge valve (engine bay) with the vent valve (back at the canister) - P0441/P0497 point at the purge side.
A loose or failing gas cap can set adjacent EVAP codes (P0455/P0456); if P0441/P0497 persist after a cap check and the code returns within a few drive cycles, the solenoid is the next step.
Typical difficulty: Moderate — based on 483 code guides for the fuel repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
check engine light
failed emissions test
no drivability symptoms
hissing sound from under the hood
slightly worse fuel mileage
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Purge valve stuck closed or clogged (most common)
Blocked purge hose
Failed purge solenoid not opening
Clogged charcoal canister
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Command the purge valve open with a scan tool and check for flow - no flow means valve or hose Tests: Purge valve stuck closed or clogged (most common)
Remove the valve and blow through it powered and unpowered to test both states
Blow compressed air through the purge hose to check for blockage Tests: Blocked purge hose
Inspect the canister for fuel saturation (from chronic overfilling of the tank) Tests: Clogged charcoal canister
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2013–2018 Acura RDX: EVAP purge control solenoid failure (P0441/P0497) - TSB B23-035 for 2018 RDX — test first, then buy for this job.
The price range below is a national planning range for P0497 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$15 – $80
Labor$0 – $180
Gas cap is under $25; smoke test plus hose/valve runs more. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0497 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Distinguish a stuck valve from a blocked hose with the blow-through test in both states.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →