Community-sourced DIY repair guides for the 2013–2018 Acura RDX, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Owner-verified repair guides
Timing belt + water pump at 105k miles or 7 years (J35 interference engine) Owner-verified(3.5L V6 (J35Z5))
Advanced DIY (half-day) or independent shop - the J35 is an interference engine, so a snapped belt means valve damage. Do the water pump, tensioner, and idlers with the belt.
Tips
The 2013-2018 RDX's J35 V6 uses a timing BELT (the 2019+ 2.0T uses a chain) - Honda's interval is 105,000 miles or 7 years, whichever comes first.
Age matters as much as miles: owners report replacing the belt on low-mileage cars purely because it aged past 7 years - belts crack with time, not just use.
The J-series is an interference engine - if the belt lets go, pistons meet valves. This is not a service to stretch.
Always replace the water pump, hydraulic tensioner, and idler pulleys with the belt - the pump is behind the belt and the labor overlaps completely.
Dealer quotes run $1,300-$1,900+; an independent Honda/Acura shop typically does the full kit job for far less. The kit itself is roughly $130-$200 in parts.
Aisin kits (OEM supplier) are the forum favorite for J-series timing jobs - avoid no-name kits on an interference engine.
EVAP purge control solenoid failure (P0441/P0497) - TSB B23-035 for 2018 RDX Factory-documented(3.5L V6 (J35Z5))
Driveway-friendly: the purge control solenoid valve is under the engine cover - disconnect the connector and hose, swap the valve, clear the code. Confirm VIN eligibility for TSB 23-035 (2018 RDX) first.
Typical difficulty: Moderate — based on 483 code guides for the fuel repair area (an area-level estimate, not this exact job).
Tips
A check-emissions light with P0441 (purge flow malfunction) or P0497 (low purge flow) on a 2nd-gen RDX usually means the EVAP purge control solenoid valve is sticking - TSB B23-035 covers the 2018 RDX for P0441 specifically.
Per the bulletin, variations in the valve's spring cause uneven wear and intermittent sticking - a new valve (P/N 36162-5G0-A02 superseding -A01) is the fix, followed by an EVAP function test.
One 2015 RDX owner fixed P0497 plus P145C with a purge valve solenoid replacement for about $70 - it's a 30-minute job under the engine cover, not a dealer-only repair.
Don't confuse the purge valve (engine bay) with the vent valve (back at the canister) - P0441/P0497 point at the purge side.
A loose or failing gas cap can set adjacent EVAP codes (P0455/P0456); if P0441/P0497 persist after a cap check and the code returns within a few drive cycles, the solenoid is the next step.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
NHTSA recorded 41 complaints for the 2013–2018 Acura RDX. 2016 was the worst year (41 complaints). Most-reported areas: power train, electrical system, engine.
19V182000 (06/03/2019) — AIR BAGS:FRONTAL:DRIVER SIDE:INFLATOR MODULE Honda (American Honda Motor Co.) is recalling specific 2003 Acura 3.2CL, 2013-2016 ILX, 2013-2014 ILX Hybrid, 2003-2006 MDX, 2007-2016 RDX, 2002-2003 3.2TL, 2004-2006, and 2009-2014 TL, 2010-2013 ZDX and 2001-2007 and 2009 Honda Accord, 2001-2005 Civic, 2003-2005 Civic Hybrid, 2001-2005…
16V061000 (03/02/2016) — AIR BAGS:FRONTAL:DRIVER SIDE:INFLATOR MODULE Honda (American Honda Motor Co.) is recalling certain model year 2007-2011 Honda CR-V, 2011-2015 CR-Z, 2010-2014 FCX, and Insight, 2009-2013 Fit, 2013-2014 Fit EV, 2007-2014 Ridgeline, 2013-2016 Acura ILX, 2013-2014 Acura ILX Hybrid, 2007-2016 RDX, 2005-2012 Acura RL, 2009-2014 Acura…
2 recall campaigns touch these years. Check your VIN at nhtsa.gov/recalls.
Factory service bulletins
We don't have factory bulletin data for the 2013–2018 Acura RDX yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.