Drive safeEmissions and idle-quality fault. Safe to drive.
The valve that lets fuel vapors into the engine isn't working right. Cheap part, usually easy to reach.
Model notes: A purge valve stuck open can also cause rough idle and hard starting right after refueling.
Key facts
P0441 means evaporative emission control system incorrect purge flow. The valve that lets fuel vapors into the engine isn't working right. Cheap part, usually easy to reach. WrenchFair's published fair-price range for this repair is $25–$80 parts and $80–$180 labor at independent shops.
WrenchFair rates P0441 a 2-of-5 DIY difficulty (“EVAP purge valve is cheap and accessible.”) with a “Drive safe” driveability rating: Emissions and idle-quality fault. Safe to drive. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Emissions warranty: P0441 is emissions-related — federal law requires up to 8 years / 80,000 miles of coverage on the catalytic converter, engine computer and OBD system. Check if your repair might be free before you pay for it.
On your 2013–2018 Acura RDX (3.5L V6 (J35Z5)) — EVAP purge control solenoid failure (P0441/P0497) - TSB B23-035 for 2018 RDX:Factory-documented
Driveway-friendly: the purge control solenoid valve is under the engine cover - disconnect the connector and hose, swap the valve, clear the code. Confirm VIN eligibility for TSB 23-035 (2018 RDX) first.
Do this test first: Blow through the EVAP purge valve - should be closed unpowered
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0441 on the 2013–2018 Acura RDX — but the community-sourced EVAP purge control solenoid failure (P0441/P0497) - TSB B23-035 for 2018 RDX note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Tips
A check-emissions light with P0441 (purge flow malfunction) or P0497 (low purge flow) on a 2nd-gen RDX usually means the EVAP purge control solenoid valve is sticking - TSB B23-035 covers the 2018 RDX for P0441 specifically.
Per the bulletin, variations in the valve's spring cause uneven wear and intermittent sticking - a new valve (P/N 36162-5G0-A02 superseding -A01) is the fix, followed by an EVAP function test.
One 2015 RDX owner fixed P0497 plus P145C with a purge valve solenoid replacement for about $70 - it's a 30-minute job under the engine cover, not a dealer-only repair.
Don't confuse the purge valve (engine bay) with the vent valve (back at the canister) - P0441/P0497 point at the purge side.
A loose or failing gas cap can set adjacent EVAP codes (P0455/P0456); if P0441/P0497 persist after a cap check and the code returns within a few drive cycles, the solenoid is the next step.
Typical difficulty: Moderate — based on 483 code guides for the fuel repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
check engine light
rough idle
hard start after refueling
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Purge valve stuck open or closed 3 owner notes link this repair to P0441
Blocked purge line 3 owner notes link this repair to P0441
Charcoal canister saturated
Owner notes linked to P0441: 3 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 2 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Blow through the EVAP purge valve - should be closed unpowered Tests: Purge valve stuck open or closed
Command it in output tests and listen for the click
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2013–2018 Acura RDX: EVAP purge control solenoid failure (P0441/P0497) - TSB B23-035 for 2018 RDX — test first, then buy for this job.
The price range below is a national planning range for P0441 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$25 – $80
Labor$80 – $180
Purge valve replacement is typical. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0441 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — EVAP purge valve is cheap and accessible.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →