Diagnose soonDrivable, but get it diagnosed. If the check-engine light is flashing or you have severe power loss, stop driving.
Can I drive with P0420?
Can I drive with a P0420 code?
Short trips and gentle driving only, until you know the cause. Drivable, but get it diagnosed. If the check-engine light is flashing or you have severe power loss, stop driving. If the check-engine light starts flashing, the engine shakes badly, or the car loses significant power, pull over safely and have it towed.
How serious is P0420?
Moderate. WrenchFair rates this one “Diagnose soon” — the car can usually get you home, but driving on it can turn a cheap fix into an expensive one. Drivable, but get it diagnosed. If the check-engine light is flashing or you have severe power loss, stop driving.
Will P0420 go away on its own?
The warning light can turn off by itself after clean drive cycles, but the code stays stored in the computer's memory and the fault is still there. Clearing it without fixing the cause just buys time — it will come back when the computer re-runs the self-test. Exception: a loose gas cap — tighten it and drive a few days.
Yes, if your state or county runs an OBD-II emissions test and the check-engine light is on. The test plugs into your car's computer, and under the EPA's OBD inspection criteria any code that commands the light on is itself a failure — no tailpipe reading needed.
Fixing the fault is only half the job. Clearing the code resets every readiness monitor, and the catalyst monitor has to run clean before the car will pass — a fresh repair with an unset catalyst monitor still fails the readiness check. Drive the car through a full drive cycle first: drive-cycle and readiness guide →
The allowance is small, and it never covers the catalyst monitor. Most states follow the EPA's rule — 1996–2000 vehicles may have up to two monitors not ready, 2001 and newer just one — and California is stricter still for 2000-and-newer gasoline vehicles, where only the EVAP monitor may be incomplete. The catalyst monitor must read ready.
Not everywhere tests: some states have no emissions test at all (South Carolina is one), and in others only certain counties test — so there, this code alone won't block registration. Rules vary by county as well as state, and they change, so confirm with your state's DMV before test day.
Your catalytic converter isn't cleaning exhaust as well as it should. Before spending $1,000+ on a new cat, rule out exhaust leaks and bad O2 sensors - they cause false alarms.
Model notes: Bank 1 is the bank containing cylinder 1. Warning: an engine that burns oil will poison a new catalytic converter - fix oil consumption first or you'll kill the replacement.
Key facts
P0420 means catalyst system efficiency below threshold, bank 1. Your catalytic converter isn't cleaning exhaust as well as it should. Before spending $1,000+ on a new cat, rule out exhaust leaks and bad O2 sensors - they cause false alarms. WrenchFair's published fair-price range for this repair is $150–$4000 parts and $150–$500 labor at independent shops.
WrenchFair rates P0420 a 3-of-5 DIY difficulty (“Diagnosis is methodical; cat replacement is bolts and rust.”) with a “Diagnose soon” driveability rating: Drivable, but get it diagnosed. If the check-engine light is flashing or you have severe power loss, stop driving. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Service bulletins: 3 factory bulletins on file for this vehicle (mostly Electrical System, Power Train, Unknown Or Other) — see the latest ones
Emissions warranty: P0420 is emissions-related — federal law requires up to 8 years / 80,000 miles of coverage on the catalytic converter, engine computer and OBD system. Check if your repair might be free before you pay for it.
On your 2015–2020 Ford F-150 (2.7L EcoBoost V6, 3.5L EcoBoost V6, 5.0L V8) — O2 (oxygen) sensors:Owner-verified
All four sensors are reached from underneath with the front raised high — upstream pair in the exhaust manifolds/downpipes, downstream pair behind the cats. Seized sensors are the known nightmare: one F150Forum owner needed an oxy/acetylene torch with the bung glowing red-hot to break one free. For stubborn front sensors, pull the passenger front wheel and wheel-well liner to get a breaker-bar angle.
Do this test first: Inspect the entire exhaust for leaks first - a leak mimics a dead cat
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0420 on the 2015–2020 Ford F-150 — but the community-sourced O2 (oxygen) sensors note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
O2 sensors: verify — Confirm against factory service info for this engine before torquing.
Tips
Check fuel trims before replacing — a lean condition can trigger O2 codes (P0131/P0151) with perfectly good sensors; the sensor is often reporting, not failing.
When a sensor is seized, heat the bung (exhaust side), never the sensor itself, and work fast — the heat spreads or fades quickly.
Use a slotted O2 sensor socket (22mm) plus long extensions from below; a flare-nut wrench helps on the tight upstream nuts on the 3.5L turbos.
Upstream (Sensor 1) failures set P0131-P0155 heater/circuit codes; downstream (Sensor 2) issues surface as P0420/P0430 cat-efficiency codes.
Typical difficulty: Moderate — based on 841 code guides for the sensors repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
check engine light
failed emissions test
sulfur smell
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Actually degraded catalyst - the most common real fix past ~100k miles (oil consumption kills cats - fix that first or you'll kill the replacement) 3 owner notes link this repair to P0420
Lazy downstream O2 sensor 4 owner notes link this repair to P0420
Exhaust leak ahead of or at the cat - check first, it's free, but a less common actual fix 3 owner notes link this repair to P0420
PCM calibration TSB causing a false code (model-specific, e.g. Toyota)
Engine running rich or lean - usually the root cause that damaged the cat, rarely a lone-P0420 cause
Owner notes linked to P0420: 14 across 6 repairs — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 3 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Inspect the entire exhaust for leaks first - a leak mimics a dead cat Tests: Exhaust leak ahead of or at the cat - check first, it's free, but a less common actual fix
Compare upstream vs downstream O2 waveforms in live data Tests: Lazy downstream O2 sensor
Check for oil consumption: a cat poisoned by oil needs the consumption fixed too Tests: Actually degraded catalyst - the most common real fix past ~100k miles (oil consumption…
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2015–2020 Ford F-150: O2 (oxygen) sensors — test first, then buy for this job.
Expensive fork: Catalytic converter — only if the downstream waveform shows a dead cat after a good sensor and no exhaust leak. Warranty check: Federal emissions warranty covers the catalytic converter for 8 years / 80,000 miles — check your warranty booklet. Inside that window the dealer replaces the cat free.
The price range below is a national planning range for P0420 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$150 – $4000
Labor$150 – $500
Three paths, very different prices: O2 sensor or exhaust gasket $150-$600 installed; aftermarket (EPA) catalytic converter $500-$1,500 installed (real shop invoice: $742 parts + $295 labor = $1,187); OEM or dealer catalytic converter $1,500-$4,000+ — in California and CARB-rule states aftermarket cats are not legal, so budget OEM-only (~$1,800+ at a dealer for common models). The ranges above span all paths; match the tier to your situation. National-average estimate. Actual quotes vary by vehicle, region, and shop — get a local written estimate. Corrected 2026-10-09 against real-world price evidence (Phase 2 adversarial audit).
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0420 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Diagnosis is methodical; cat replacement is bolts and rust.
Fixed it, but will it pass inspection? Clearing the code resets every readiness monitor, and a permanent code only clears when its monitor runs clean. Cleared it. Still failed. →
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →