P0405: Exhaust gas recirculation sensor A circuit low
DIY difficulty 3/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Drive safeEmissions-related fault. Safe to drive; may affect fuel economy slightly.
The sensor reporting the exhaust valve's position is reading too low. The computer can't accurately control exhaust recycling.
VW/Audi note (VCDS): Sweep the valve manually and watch the position PID; dropouts or flat spots condemn the sensor.
Model notes: EGR position sensors are usually part of the valve assembly - a sensor fault often means replacing the whole valve, so be sure of the diagnosis.
Key facts
P0405 means exhaust gas recirculation sensor A circuit low. The sensor reporting the exhaust valve's position is reading too low. The computer can't accurately control exhaust recycling. WrenchFair's published fair-price range for this repair is $80–$250 parts and $150–$350 labor at independent shops.
WrenchFair rates P0405 a 3-of-5 DIY difficulty (“Low circuit usually means wiring - check reference and ground before replacing the valve assembly.”) with a “Drive safe” driveability rating: Emissions-related fault. Safe to drive; may affect fuel economy slightly. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light
EGR performance complaints
failed emissions test
Likely causes
Sensor signal wire shorted to ground or open (most common)
Failed EGR position sensor
Corroded connector
5V reference problem
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check 5V reference and ground at the sensor Tests: Sensor signal wire shorted to ground or open (most common)
Unplug the sensor - if the reading stays pinned low, the wiring is shorted Tests: Sensor signal wire shorted to ground or open (most common)
Manually move the valve (where possible) and watch the sensor sweep
Replace the assembly if the sensor cannot sweep properly
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$80 – $250
Labor$150 – $350
EGR valve replacement is typical. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0405 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Low circuit usually means wiring - check reference and ground before replacing the valve assembly.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →