P0405

P0405: Exhaust gas recirculation sensor A circuit low

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The sensor reporting the exhaust valve's position is reading too low. The computer can't accurately control exhaust recycling.

VW/Audi note (VCDS): Sweep the valve manually and watch the position PID; dropouts or flat spots condemn the sensor.
Model notes: EGR position sensors are usually part of the valve assembly - a sensor fault often means replacing the whole valve, so be sure of the diagnosis.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check 5V reference and ground at the sensor Tests: Sensor signal wire shorted to ground or open (most common)
  2. Unplug the sensor - if the reading stays pinned low, the wiring is shorted Tests: Sensor signal wire shorted to ground or open (most common)
  3. Manually move the valve (where possible) and watch the sensor sweep
  4. Replace the assembly if the sensor cannot sweep properly

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$80 – $250
Labor$150 – $350

EGR valve replacement is typical. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0405 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Low circuit usually means wiring - check reference and ground before replacing the valve assembly.

Watch this repair on YouTube

Parts & tools

EGR toolkit — what the job actually takes

Torque specs: Typically 20–30 Nm into iron, less into aluminum — verify spec.

Pro tip: Clean the passages, not just the valve — a new valve on clogged passages throws the same code.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →