P0365

P0365: Camshaft position sensor B circuit malfunction, bank 1

For your specific vehicle: P0365 on a 2016–2016 Dodge Journey

DIY difficulty 2/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The sensor monitoring the exhaust camshaft has an electrical fault. On high-mileage engines this can also be a sign the timing chain has stretched.

VW/Audi note (VCDS): Check camshaft/crankshaft correlation values; excessive deviation means the timing set is worn, not the sensor.
Model notes: Sensor B (exhaust cam) codes on high-mileage engines deserve a timing chain stretch check - the sensor is often reporting correctly that the cam is not where the ECM expects it.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Test the sensor and its wiring the same as any cam sensor
  2. If the sensor is good, check camshaft correlation PIDs - a stretched timing chain shows up as cam/crank misalignment
  3. Verify oil level and pressure - phaser faults can set sensor circuit codes Tests: Low oil pressure affecting the exhaust cam phaser
  4. Do not ignore timing chain wear on high-mileage engines with cam codes Tests: Timing component wear causing the signal to drift out of expected range

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$30 – $120
Labor$80 – $180

Camshaft/crankshaft position sensor or wiring repair is the typical fix. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0365 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — Exhaust cam sensors are usually as accessible as intake ones; verify timing components if the sensor tests good.

Watch this repair on YouTube

Parts & tools

Spark plug & coil toolkit — what the job actually takes

Torque specs: Gasket-seat plugs: typically 20–30 Nm (15–22 lb-ft). Tapered-seat plugs: typically 11–18 Nm. Always verify against your engine’s factory spec — over-torquing strips aluminum threads.

Pro tip: Blow out the plug wells with compressed air BEFORE removing the plugs, so debris can’t fall into the cylinders.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →