P0342: Camshaft position sensor 'A' circuit low - bank 1
DIY difficulty 3/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonThe engine may run in a limp mode - fix before it leaves you stranded.
The intake camshaft sensor on bank 1 is shorted - the computer may lose track of valve timing.
Key facts
P0342 means camshaft position sensor 'A' circuit low - bank 1. The intake camshaft sensor on bank 1 is shorted - the computer may lose track of valve timing. WrenchFair's published fair-price range for this repair is $40–$120 parts and $80–$250 labor at independent shops.
WrenchFair rates P0342 a 3-of-5 DIY difficulty (“The sensor is on the cylinder head - usually reachable.”) with a “Diagnose soon” driveability rating: The engine may run in a limp mode - fix before it leaves you stranded. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light
hard start or extended cranking
rough running
reduced power
Likely causes
Shorted camshaft position sensor (most common)
Wiring shorted to ground
Damaged reluctor or tone ring
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check the cam signal on a scan tool while cranking
Test the sensor's resistance
Inspect the wiring for shorts to ground Tests: Wiring shorted to ground
Replace the sensor if shorted internally Tests: Shorted camshaft position sensor (most common)
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$40 – $120
Labor$80 – $250
Camshaft position sensor replacement (bank 1). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0342 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — The sensor is on the cylinder head - usually reachable.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →