Diagnose soonMisfires can damage the catalytic converter. Drive gently to a shop; if the check-engine light is flashing, stop driving.
The crankshaft sensor's signal keeps cutting in and out, causing random stalling that comes and goes. Frustrating, but the sensor itself is usually the culprit.
Model notes: Intermittent crank sensor faults often set no code until they get bad - if the symptoms fit but there is no code yet, the sensor is still the prime suspect.
Key facts
P0339 means crankshaft position sensor A circuit intermittent. The crankshaft sensor's signal keeps cutting in and out, causing random stalling that comes and goes. Frustrating, but the sensor itself is usually the culprit. WrenchFair's published fair-price range for this repair is $30–$120 parts and $80–$180 labor at independent shops.
WrenchFair rates P0339 a 3-of-5 DIY difficulty (“Intermittent faults are hard to catch in the act; the pattern of symptoms is often the best evidence.”) with a “Diagnose soon” driveability rating: Misfires can damage the catalytic converter. Drive gently to a shop; if the check-engine light is flashing, stop driving. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2007–2015 Jeep Patriot (2.0L World I4, 2.4L World I4) — Intermittent stall / P0335 / P0339:Owner-verified
The sensor lives at the rear of the engine block near the transmission. Reach it from underneath with the car on ramps or stands; AWD models need the power transfer unit out of the way first per the service manual.
Do this test first: Wiggle-test the connector and harness with the engine running - if it stumbles, you found it
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0339 on the 2007–2015 Jeep Patriot — but the community-sourced Intermittent stall / P0335 / P0339 note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Crankshaft position sensor bolt: verify — Torque spec for the sensor bolt not confirmed from a forum source — confirm against factory service info before torquing.
Tips
If your Patriot dies randomly at speed or at idle, restarts after sitting, and stores P0335 or P0339, the crankshaft position sensor is the classic culprit. A DIY owner filmed the swap on a 2.4L World engine (same procedure on Compass, Patriot, and Caliber) and reports it cured the random dying.
Use an OEM sensor. A 2CarPros thread shows an owner who installed an aftermarket Duralast sensor and continued to have intermittent stalls with P0335/P0339; the techs in that thread steer him back to an OEM unit because aftermarket crank sensors are a known repeat failure on these.
Disconnect the battery and inspect the sensor connector and wiring before you swap the sensor. The recall documents for the related 2016 campaign describe corroded or intermittent sensor connectors producing the exact same stall, and a corroded connector will make even a good sensor look dead.
Plan for a cam/crank relearn with a scan tool after replacement. Per 2CarPros, there is no scanner-free relearn for these — the PCM needs a scan tool to learn the new sensor's position values, though it is generally safe to drive to the shop that has one.
Note the recall boundary: 2016 Patriots built May 9 to July 15, 2016 fall under FCA recall S89 (16V-907) for the crank/cam sensor connector and get a free dealer fix. Check your build date before buying parts.
Typical difficulty: Moderate — based on 841 code guides for the sensors repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
random stalling
intermittent no-start
bucking or cutting out
tachometer flickering
hesitation upon acceleration
reduced fuel economy
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Failing crank sensor with heat-related intermittency (most common)
Loose or corroded connector making intermittent contact
Chafed wiring that shorts when the engine rocks on its mounts
Debris or metal shavings on the magnetic sensor tip
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Wiggle-test the connector and harness with the engine running - if it stumbles, you found it Tests: Loose or corroded connector making intermittent contact
Inspect the connector pins for spread terminals or green corrosion Tests: Loose or corroded connector making intermittent contact
Clean any metal debris off the sensor tip Tests: Debris or metal shavings on the magnetic sensor tip
If the pattern is heat-related stalling, replace the sensor - thermal intermittency does not heal Tests: Failing crank sensor with heat-related intermittency (most common)
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2007–2015 Jeep Patriot: Intermittent stall / P0335 / P0339 — test first, then buy for this job.
The price range below is a national planning range for P0339 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$30 – $120
Labor$80 – $180
Camshaft/crankshaft position sensor or wiring repair is the typical fix. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0339 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Intermittent faults are hard to catch in the act; the pattern of symptoms is often the best evidence.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →