P0339

P0339: Crankshaft position sensor A circuit intermittent

For your specific vehicle: P0339 on a 2007–2015 Jeep Patriot

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The crankshaft sensor's signal keeps cutting in and out, causing random stalling that comes and goes. Frustrating, but the sensor itself is usually the culprit.

VW/Audi note (VCDS): Record RPM on a test drive and review the log after a stall; dropouts in the RPM trace reveal intermittency that live viewing misses.
Model notes: Intermittent crank sensor faults often set no code until they get bad - if the symptoms fit but there is no code yet, the sensor is still the prime suspect.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Wiggle-test the connector and harness with the engine running - if it stumbles, you found it Tests: Loose or corroded connector making intermittent contact
  2. Inspect the connector pins for spread terminals or green corrosion Tests: Loose or corroded connector making intermittent contact
  3. Clean any metal debris off the sensor tip Tests: Debris or metal shavings on the magnetic sensor tip
  4. If the pattern is heat-related stalling, replace the sensor - thermal intermittency does not heal Tests: Failing crank sensor with heat-related intermittency (most common)

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$30 – $120
Labor$80 – $180

Camshaft/crankshaft position sensor or wiring repair is the typical fix. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0339 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Intermittent faults are hard to catch in the act; the pattern of symptoms is often the best evidence.

Watch this repair on YouTube

Parts & tools

Spark plug & coil toolkit — what the job actually takes

Torque specs: Gasket-seat plugs: typically 20–30 Nm (15–22 lb-ft). Tapered-seat plugs: typically 11–18 Nm. Always verify against your engine’s factory spec — over-torquing strips aluminum threads.

Pro tip: Blow out the plug wells with compressed air BEFORE removing the plugs, so debris can’t fall into the cylinders.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →