Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Stop drivingNo crank signal means no-start or stalling in traffic - tow it if it won't run reliably.
The crankshaft position sensor's signal is shorted - the computer may lose track of engine position entirely.
Key facts
P0337 means crankshaft position sensor 'A' circuit low. The crankshaft position sensor's signal is shorted - the computer may lose track of engine position entirely. WrenchFair's published fair-price range for this repair is $40–$150 parts and $100–$250 labor at independent shops.
WrenchFair rates P0337 a 3-of-5 DIY difficulty (“The sensor is usually low on the block near the crank pulley or flywheel.”) with a “Stop driving” driveability rating: No crank signal means no-start or stalling in traffic - tow it if it won't run reliably. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light
no-start or hard start
stalling
misfires
Likely causes
Shorted crankshaft position sensor (most common)
Wiring shorted to ground
Damaged reluctor or tone ring
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Watch for an RPM signal while cranking
Test the sensor's resistance
Inspect the wiring for shorts to ground Tests: Wiring shorted to ground
Check the reluctor for damage Tests: Damaged reluctor or tone ring
Replace the sensor if shorted internally
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$40 – $150
Labor$100 – $250
Crankshaft position sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0337 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — The sensor is usually low on the block near the crank pulley or flywheel.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →