Diagnose soonMisfires can damage the catalytic converter. Drive gently to a shop; if the check-engine light is flashing, stop driving.
The engine stumbles for the first few seconds after a cold start, then smooths out. The classic cause is a fuel injector that drips gasoline into a cylinder overnight.
Model notes: If the engine starts rough but smooths out within 30 seconds, suspect fuel leaking into cylinders overnight rather than ignition parts - ignition misfires usually persist when warm.
Key facts
P0316 means engine misfire detected on startup (first 1000 revolutions). The engine stumbles for the first few seconds after a cold start, then smooths out. The classic cause is a fuel injector that drips gasoline into a cylinder overnight. WrenchFair's published fair-price range for this repair is $30–$120 parts and $80–$180 labor at independent shops.
WrenchFair rates P0316 a 3-of-5 DIY difficulty (“Overnight leak-down testing takes patience; the diagnosis spans fuel, ignition, and mechanical causes.”) with a “Diagnose soon” driveability rating: Misfires can damage the catalytic converter. Drive gently to a shop; if the check-engine light is flashing, stop driving. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Service bulletins: 434 factory bulletins on file for this vehicle (mostly Electrical System, Equipment, Power Train) — see the latest ones
On your 2013–2019 Ford Escape (1.5L EcoBoost I4, 1.6L EcoBoost I4, 2.0L EcoBoost I4) — EcoBoost coolant intrusion (misfire + coolant loss):Owner-verified
No teardown needed to diagnose. Watch the coolant reservoir over a week of normal driving, pull the spark plugs and look down the bores with a cheap borescope, and pressure-test the cooling system. The failure lives between cylinders 2 and 3 on the open-deck block.
Do this test first: Check which cylinders misfire on startup using misfire counters - one cylinder points at its injector or plug, random points at fuel pressure or battery
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0316 on the 2013–2019 Ford Escape — but the community-sourced EcoBoost coolant intrusion (misfire + coolant loss) note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Engine replacement fasteners: verify — Engine replacement is not a DIY torque procedure — confirm all specs against factory service info if the long block is installed outside a dealer.
Tips
Learn the signature pattern before spending a dollar: coolant level dropping with no puddle under the car, rough idle on cold starts that smooths out, white exhaust smoke, and misfire codes (often cylinder 2 or 3). A 2018 1.5L owner at 22,000 miles went in expecting a coil and came out with an engine replacement — the dealer found coolant in cylinder 2 and indentation on the block.
Do not chase this with spark plugs and coils. Multiple owners and Ford's own bulletins confirm the root cause is the open-deck block design: cooling slits between the cylinders warp, the head seal fails, and coolant enters the combustion chamber. New plugs will not fix a cracked sealing surface.
Ford's documented fix is an engine replacement, not a gasket. TSB 19-2346 (2.0L) and TSB 22-2229 (2015-2018 2.0L applications) call for a long-block assembly; out-of-warranty owners report $6,000-$8,000. Stop-leak products will not seal a warped deck and risk clogging the cooling system.
Check your VIN for open service programs and recalls before paying out of pocket — coverage has varied by year and program. NHTSA's Office of Defects Investigation is evaluating a defect petition on these engines and class-action lawsuits are active, so keep every repair order and invoice.
A 2020 1.5L three-cylinder owner documented the same failure mode (coolant in cylinder 3, scored cylinder walls, block distortion) ending in a long-block replacement after the short block went on indefinite backorder — so 4th-gen 1.5L owners should watch coolant level just as closely.
Typical difficulty: Moderate — based on 85 code guides for the engine repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
rough running for the first seconds after cold start
check engine light after cold starts
fuel smell on startup
symptoms clear as the engine warms
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Leaking fuel injector flooding a cylinder overnight (most common - starts rough, clears up)
Worn spark plugs with weak cold-start spark 3 owner notes link this repair to P0316
Carbon buildup on intake valves affecting cold mixture
Weak battery or slow cranking reducing cold-start spark energy 3 owner notes link this repair to P0316
Incorrect engine oil viscosity making cold cranking sluggish
Owner notes linked to P0316: 4 across 2 repairs — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check which cylinders misfire on startup using misfire counters - one cylinder points at its injector or plug, random points at fuel pressure or battery Tests: Leaking fuel injector flooding a cylinder overnight (most common - starts rough, clears…
Test fuel pressure leak-down overnight: pressure that bleeds off points at a leaking injector or check valve Tests: Leaking fuel injector flooding a cylinder overnight (most common - starts rough, clears…
Pull plugs on the offending cylinders after an overnight sit - wet plugs confirm injector leak-down Tests: Leaking fuel injector flooding a cylinder overnight (most common - starts rough, clears…
Load-test the battery - marginal batteries cause exactly this symptom on cold mornings Tests: Weak battery or slow cranking reducing cold-start spark energy
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2013–2019 Ford Escape: EcoBoost coolant intrusion (misfire + coolant loss) — test first, then buy for this job.
The price range below is a national planning range for P0316 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$30 – $120
Labor$80 – $180
Coils and spark plugs are the typical fix. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0316 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Overnight leak-down testing takes patience; the diagnosis spans fuel, ignition, and mechanical causes.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →