P0315

P0315: Crankshaft position system variation not learned

DIY difficulty 2/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The engine computer needs to 'learn' the characteristics of a new crankshaft sensor, and that learn procedure was never done. It's a quick scan-tool procedure, not a broken part.

VW/Audi note (VCDS): Look for a crankshaft variation learn or CASE learn function in your scan tool's special functions menu; generic tools often have it under the engine module.
Model notes: This code commonly appears after DIY crank sensor replacement - the sensor job is only half done until the relearn is performed. Some vehicles also need it after a battery disconnect or ECM update.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Bring the engine to full operating temperature and resolve any other codes first
  2. Follow the relearn procedure: typically involves holding a specific RPM for several seconds while the tool commands the learn Tests: Crankshaft position sensor replaced without performing the relearn procedure (most common)
  3. If the relearn fails, check that all enable criteria are met (coolant temp, no other codes, correct RPM) Tests: Relearn procedure attempted but failed due to unmet enable criteria
  4. After a successful relearn, road test and confirm misfire detection behaves normally Tests: Crankshaft position sensor replaced without performing the relearn procedure (most common)

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$30 – $120
Labor$80 – $180

A crankshaft position variation relearn with a scan tool is the typical fix. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0315 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — The fix is a procedure, not a part - but it requires a scan tool that can command the relearn.

Watch this repair on YouTube

Parts & tools

Spark plug & coil toolkit — what the job actually takes

Torque specs: Gasket-seat plugs: typically 20–30 Nm (15–22 lb-ft). Tapered-seat plugs: typically 11–18 Nm. Always verify against your engine’s factory spec — over-torquing strips aluminum threads.

Pro tip: Blow out the plug wells with compressed air BEFORE removing the plugs, so debris can’t fall into the cylinders.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →