P0232

P0232 on a 2015–2020 Ford F-150: Fuel pump secondary circuit high

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: P0232 on a 2015–2020 Ford F-150 · 2016–2021 Honda Civic

DIY difficulty 2/5

The fuel pump's feedback circuit reads high - the pump may be stuck running. Expect a drained battery or fuel delivery faults.

Key facts

☑ Before you buy parts — check these first:
On your 2015–2020 Ford F-150 (2.7L EcoBoost V6, 3.5L EcoBoost V6, 5.0L V8) — Fuel pump replacement: Owner-verified
The pump is an in-tank module with no service access panel in the bed: you either drop the tank (two straps; support it with a floor jack) or lift/slide the bed back. Drain or siphon the tank as empty as possible first. Per a 2015 F-150 2.7L walkthrough, unbolt the filler neck from the body, lower the tank slightly so the neck drops with it, then loosen the clamp with a ratchet wrench for easy access. The module is held by a plastic lock ring tapped counterclockwise with a brass punch and hammer; the electrical connector has a red slider lock (slide the red tab out, then push down on the tab at the connector end) and the EVAP/fuel lines use squeeze-to-release quick connectors.
Do this test first: Listen for the pump running with the key off
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0232 on the 2015–2020 Ford F-150 — but the community-sourced Fuel pump replacement note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Torque specs

Tips

Sources: TRQ/1A Auto walkthrough: How to Replace Fuel Pump Assembly 2015-2020 Ford F-150 (done on 2015 XLT 3.5L; tools include brass punch, hammer) · 1A Auto fuel pump replacement guide (tank removal, lock-ring hammer method) · JustAnswer: 2015 Ford F-150 2.7L fuel tank removal tips (filler neck, connector red-tab lock) · f150forum: Fuel Pump thread (2016 3.5 EcoBoost failure discussion, pump-only swap tip)

Typical difficulty: Moderate — based on 483 code guides for the fuel repair area (an area-level estimate, not this exact job).

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Owner notes linked to P0232: 2 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Listen for the pump running with the key off
  2. Pull and test the fuel pump relay - swap with a matching one Tests: Fuel pump relay stuck closed (most common)
  3. Check for shorts to voltage in the pump circuit Tests: Short to voltage in the pump circuit
  4. Inspect the feedback wiring Tests: Faulty feedback wiring

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2015–2020 Ford F-150: Fuel pump replacement — test first, then buy for this job.
The price range below is a national planning range for P0232 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$15 – $50
Labor$0 – $100

Fuel pump relay replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0232 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — Pull the relay and listen - a stuck relay is a five-minute fix.

Watch this repair on YouTube

Parts & tools

Fuel system toolkit — what the job actually takes

Torque specs: Fuel rail bolts: typically 8–12 Nm — verify spec.

Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →