Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonThe ECM is adding fuel based on a possibly false lean reading - diagnose soon to protect the catalyst.
Your bank-2 front oxygen sensor is stuck reading lean - it could be lying (bad sensor, exhaust leak) or the engine could actually be running lean.
Key facts
P0151 means o2 sensor circuit low voltage, bank 2 sensor 1. Your bank-2 front oxygen sensor is stuck reading lean - it could be lying (bad sensor, exhaust leak) or the engine could actually be running lean. WrenchFair's published fair-price range for this repair is $40–$150 parts and $80–$180 labor at independent shops.
WrenchFair rates P0151 a 2-of-5 DIY difficulty (“Rule out exhaust leaks and real lean conditions before replacing the sensor - the ECM adds fuel based on this reading.”) with a “Diagnose soon” driveability rating: The ECM is adding fuel based on a possibly false lean reading - diagnose soon to protect the catalyst. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light
poor fuel economy
rough idle
hesitation
Likely causes
Failed O2 sensor stuck lean (most common)
Exhaust leak ahead of the sensor pulling in outside air
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check for exhaust leaks ahead of the sensor Tests: Exhaust leak ahead of the sensor pulling in outside air
Look for vacuum leaks or fuel delivery problems causing a real lean condition Tests: Genuine lean condition (vacuum leak, low fuel pressure)
Watch the sensor voltage - stuck near 0.1V with no movement suggests a dead sensor Tests: Failed O2 sensor stuck lean (most common)
Check the wiring for shorts to ground Tests: Wiring short to ground
Replace the sensor if the mixture is actually fine and the wiring is good
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$40 – $150
Labor$80 – $180
Upstream oxygen sensor replacement (bank 2 sensor 1) or lean-condition repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0151 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Rule out exhaust leaks and real lean conditions before replacing the sensor - the ECM adds fuel based on this reading.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →