P0037: O2 sensor heater circuit low, bank 1 sensor 2
DIY difficulty 2/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Drive safeNo driveability impact - but find the short before it blows the shared heater fuse and sets more codes.
The heater circuit in your rear oxygen sensor (after the catalytic converter) is shorted to ground. The car drives fine - this sensor only monitors the catalytic converter.
Key facts
P0037 means o2 sensor heater circuit low, bank 1 sensor 2. The heater circuit in your rear oxygen sensor (after the catalytic converter) is shorted to ground. The car drives fine - this sensor only monitors the catalytic converter. WrenchFair's published fair-price range for this repair is $40–$130 parts and $80–$160 labor at independent shops.
WrenchFair rates P0037 a 2-of-5 DIY difficulty (“Unplugging the sensor separates a harness short from a sensor short quickly.”) with a “Drive safe” driveability rating: No driveability impact - but find the short before it blows the shared heater fuse and sets more codes. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light
no driveability symptoms
Likely causes
Heater wiring shorted to ground
Shorted heater element inside the O2 sensor
Corroded connector bridging the circuit to ground
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check the O2 heater fuse - a blown fuse confirms a short
Unplug the sensor and see if the short-to-ground reading clears
With the sensor unplugged, test the heater feed wire for continuity to ground and repair chafed sections Tests: Heater wiring shorted to ground
Inspect wiring near hot exhaust parts
Measure the sensor's heater resistance against factory spec
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$40 – $130
Labor$80 – $160
Downstream oxygen sensor replacement or heater wiring repair (bank 1 sensor 2). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0037 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Unplugging the sensor separates a harness short from a sensor short quickly.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →