P0151

P0151: O2 sensor circuit low voltage, bank 2 sensor 1

For your specific vehicle: P0151 on a 2015–2020 Ford F-150

DIY difficulty 2/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

Your bank-2 front oxygen sensor is stuck reading lean - it could be lying (bad sensor, exhaust leak) or the engine could actually be running lean.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 5 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check for exhaust leaks ahead of the sensor Tests: Exhaust leak ahead of the sensor pulling in outside air
  2. Look for vacuum leaks or fuel delivery problems causing a real lean condition Tests: Genuine lean condition (vacuum leak, low fuel pressure)
  3. Watch the sensor voltage - stuck near 0.1V with no movement suggests a dead sensor Tests: Failed O2 sensor stuck lean (most common)
  4. Check the wiring for shorts to ground Tests: Wiring short to ground
  5. Replace the sensor if the mixture is actually fine and the wiring is good

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$40 – $150
Labor$80 – $180

Upstream oxygen sensor replacement (bank 2 sensor 1) or lean-condition repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0151 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — Rule out exhaust leaks and real lean conditions before replacing the sensor - the ECM adds fuel based on this reading.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: O2 sensors: typically 35–50 Nm (26–37 lb-ft) — verify spec. A dab of nickel anti-seize on the threads; keep it off the sensor tip.

Pro tip: Route the new sensor’s harness exactly like the old one — melted wires on the exhaust are the number-one comeback.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →