Drive safeEmissions and fuel-economy issue. Safe to drive - fix when convenient, but don't ignore it forever.
Can I drive with P0137?
Can I drive with a P0137 code?
Yes. P0137 doesn't make your car unsafe to drive on its own. Emissions and fuel-economy issue. Safe to drive - fix when convenient, but don't ignore it forever. Fix it when convenient rather than putting it off indefinitely — even a minor fault can turn into a bigger bill if the underlying cause gets worse.
How serious is P0137?
Low. WrenchFair rates this one “Drive safe” — the least serious of its three driveability ratings. It's a fix-on-your-schedule fault, not a same-day emergency. Emissions and fuel-economy issue. Safe to drive - fix when convenient, but don't ignore it forever.
Will P0137 go away on its own?
The warning light can turn off by itself after clean drive cycles, but the code stays stored in the computer's memory and the fault is still there. Clearing it without fixing the cause just buys time — it will come back when the computer re-runs the self-test. Exception: a loose gas cap — tighten it and drive a few days.
The sensor behind your catalytic converter is reading too much oxygen in the exhaust. Usually that means a small exhaust leak is letting outside air in near the sensor.
Model notes: Exhaust leaks are the number-one cause and the cheapest fix - a $5 gasket beats a $500 converter. Listen for ticking at the manifold on cold start.
Key facts
P0137 means o2 sensor circuit low voltage, bank 1 sensor 2. The sensor behind your catalytic converter is reading too much oxygen in the exhaust. Usually that means a small exhaust leak is letting outside air in near the sensor. WrenchFair's published fair-price range for this repair is $40–$130 parts and $75–$180 labor at independent shops.
WrenchFair rates P0137 a 2-of-5 DIY difficulty (“The code is easy to read; the skill is deciding between an exhaust leak, a bad sensor, and a dead converter.”) with a “Drive safe” driveability rating: Emissions and fuel-economy issue. Safe to drive - fix when convenient, but don't ignore it forever. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Service bulletins: 515 factory bulletins on file for this vehicle (mostly Equipment, Electrical System, Engine) — see the latest ones
Emissions warranty: P0137 is emissions-related — federal law requires up to 8 years / 80,000 miles of coverage on the catalytic converter, engine computer and OBD system. Check if your repair might be free before you pay for it.
On your 2019–2024 Toyota RAV4 (2.5L 4-cyl (A25A-FKS)) — O2 (oxygen) sensors:Owner-verified
Toyota uses an air/fuel ratio sensor upstream, not a conventional narrow-band O2: Bank 1 Sensor 1 threads into the exhaust manifold ahead of the catalytic converter, and Bank 1 Sensor 2 sits downstream of the cat. Unclip the wiring connector from its mounting bracket first, then back the sensor out with a 22 mm O2 sensor socket. Owners on rav4world.com describe the upstream swap as a roughly 20-minute, sub-$100 DIY versus about $400 at a dealer.
Do this test first: Inspect the exhaust from the manifold to past the downstream sensor for leaks - even a pinhole ahead of the sensor sets this code
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0137 on the 2019–2024 Toyota RAV4 — but the community-sourced O2 (oxygen) sensors note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Air/fuel ratio sensor (M18x1.5): verify — Confirm against factory service info for this engine before torquing.
Tips
Order by position: upstream B1S1 is an air/fuel ratio sensor — Denso 234-9307 (Toyota 89467-06250 / 89467-33290) — while downstream B1S2 is a conventional heated O2 sensor; they are not interchangeable.
A failed upstream A/F sensor commonly throws downstream codes (e.g., P0137 B1S2 low voltage) — rav4world members resolved a persistent P0137 by replacing the upstream A/F sensor, so check upstream sensor data before replacing the downstream one.
Thread size is M18x1.5 with a 22 mm hex; clear codes after install and drive full heat cycles before judging the fix — a lazy upstream sensor can also set P0171 lean codes.
Typical difficulty: Moderate — based on 841 code guides for the sensors repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
check engine light
failed emissions test
possible lean-running symptoms if the engine itself is lean
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Exhaust leak upstream of or near the downstream sensor pulling in air (very common) 2 owner notes link this repair to P0137
Failing catalytic converter that can no longer store oxygen 2 owner notes link this repair to P0137
Failed downstream O2 sensor reading low 2 owner notes link this repair to P0137
Vacuum leak or lean running condition flooding the exhaust with oxygen 2 owner notes link this repair to P0137
Owner notes linked to P0137: 2 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Inspect the exhaust from the manifold to past the downstream sensor for leaks - even a pinhole ahead of the sensor sets this code Tests: Exhaust leak upstream of or near the downstream sensor pulling in air (very common)
Check fuel trims: if long-term trims are high positive, fix the lean condition first Tests: Vacuum leak or lean running condition flooding the exhaust with oxygen
If no leaks and trims are normal, the sensor or the converter is suspect - compare sensor behavior before replacing either Tests: Exhaust leak upstream of or near the downstream sensor pulling in air (very common)
Do not replace the converter until leaks and the sensor are ruled out - converters are expensive Tests: Exhaust leak upstream of or near the downstream sensor pulling in air (very common)
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2019–2024 Toyota RAV4: O2 (oxygen) sensors — test first, then buy for this job.
Expensive fork: Catalytic converter — only if the downstream waveform shows a dead cat after a good sensor and no exhaust leak.
The price range below is a national planning range for P0137 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$40 – $130
Labor$75 – $180
O2 sensor replacement is the typical fix. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0137 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — The code is easy to read; the skill is deciding between an exhaust leak, a bad sensor, and a dead converter.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →