Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonBoost control accuracy is degraded - diagnose soon.
The sensor measuring pressure at your turbo's inlet has an electrical fault. The computer's boost calculations get less accurate.
Model notes: Found on engines that model turbocharger behavior closely (some Ford EcoBoost, GM, and diesel applications).
Key facts
P012A means turbocharger inlet pressure sensor circuit fault. The sensor measuring pressure at your turbo's inlet has an electrical fault. The computer's boost calculations get less accurate. WrenchFair's published fair-price range for this repair is $30–$150 parts and $80–$200 labor at independent shops.
WrenchFair rates P012A a 2-of-5 DIY difficulty (“Check the factory manual for the sensor's location - it varies by design.”) with a “Diagnose soon” driveability rating: Boost control accuracy is degraded - diagnose soon. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light
reduced power
poor boost response
Likely causes
Failed turbo inlet pressure sensor (most common)
Damaged wiring or connector
Open or short in the sensor circuit
Blocked sensor port
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Locate the turbo inlet pressure sensor per the factory manual Tests: Failed turbo inlet pressure sensor (most common)
Inspect the wiring, connector, and sensor port for blockage Tests: Damaged wiring or connector
Check for opens or shorts in the circuit Tests: Open or short in the sensor circuit
Test the sensor's output against factory spec and replace if bad
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$30 – $150
Labor$80 – $200
Turbocharger inlet pressure sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P012A ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Check the factory manual for the sensor's location - it varies by design.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →