P0111: Intake air temperature sensor circuit range/performance
DIY difficulty 1/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonBad air measurement causes poor running and possible limp mode. Drive gently.
The incoming-air temperature sensor is giving readings that don't add up - it's drifting with age rather than completely dead. Usually just needs replacement.
VW/Audi note (VCDS): Log IAT, ECT, and ambient on a cold start; all three should start together and diverge sensibly as the engine warms.
Model notes: IAT rationality codes often appear alongside MAF codes when an oiled filter has contaminated the combined sensor - clean or replace as a unit.
Key facts
P0111 means intake air temperature sensor circuit range/performance. The incoming-air temperature sensor is giving readings that don't add up - it's drifting with age rather than completely dead. Usually just needs replacement. WrenchFair's published fair-price range for this repair is $10–$250 parts and $50–$150 labor at independent shops.
WrenchFair rates P0111 a 1-of-5 DIY difficulty (“Rationality testing with a cold engine identifies a drifting sensor quickly.”) with a “Diagnose soon” driveability rating: Bad air measurement causes poor running and possible limp mode. Drive gently. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Heat soak from a hot engine bay skewing readings on some designs
Partial wiring damage adding resistance
Aftermarket intake placing the sensor in a hot zone
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Cold-soak test: after sitting overnight, IAT should match ambient and coolant temp within a few degrees
If IAT reads wrong while coolant temp is correct, the IAT sensor is drifting Tests: Drifting IAT sensor reading incorrectly (most common)
Check for aftermarket intake modifications relocating the sensor Tests: Aftermarket intake placing the sensor in a hot zone
Replace the sensor if it fails the rationality test
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$10 – $250
Labor$50 – $150
Cleaning is cheap; sensor replacement costs more. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0111 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
1 of 5 — Rationality testing with a cold engine identifies a drifting sensor quickly.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →