Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonLimp mode means reduced power - avoid highways until diagnosed.
The air-measurement sensor's signal is too weak - usually a wiring problem or a dead sensor. The car may go into limp mode.
VW/Audi note (VCDS): No reference voltage at the connector means wiring or fuse, not the sensor.
Model notes: Check the 5V reference and ground at the MAF connector with a multimeter before buying a sensor.
Key facts
P0102 means mass air flow sensor circuit low input. The air-measurement sensor's signal is too weak - usually a wiring problem or a dead sensor. The car may go into limp mode. WrenchFair's published fair-price range for this repair is $80–$250 parts and $80–$200 labor at independent shops.
WrenchFair rates P0102 a 2-of-5 DIY difficulty (“Wiring checks need a multimeter and patience.”) with a “Diagnose soon” driveability rating: Limp mode means reduced power - avoid highways until diagnosed. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
limp mode
check engine light
poor performance
Likely causes
Failed MAF sensor
Broken wire or corroded connector
Blown sensor fuse / missing reference voltage
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 3 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check 5V reference and ground at the MAF connector Tests: Broken wire or corroded connector
Inspect wiring for chafing
Swap in a known-good MAF
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$80 – $250
Labor$80 – $200
Sensor replacement; wiring repairs add labor. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0102 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Wiring checks need a multimeter and patience.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →