Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonRich running wastes fuel and can foul the catalyst - address it soon.
Your second airflow sensor is reading too high - it's skewed, dirty, or there's a wiring fault. The engine will run rich.
Key facts
P00BD means mAF sensor 'B' circuit high. Your second airflow sensor is reading too high - it's skewed, dirty, or there's a wiring fault. The engine will run rich. WrenchFair's published fair-price range for this repair is $60–$250 parts and $80–$200 labor at independent shops.
WrenchFair rates P00BD a 2-of-5 DIY difficulty (“Clean the sensor first; compare against the 'A' sensor's reading.”) with a “Diagnose soon” driveability rating: Rich running wastes fuel and can foul the catalyst - address it soon. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light
rich running
poor fuel economy
black smoke
rough idle
Likely causes
Contaminated or skewed 'B' MAF sensor (most common)
Wiring fault driving the signal high
Intake leak causing turbulent false-high readings
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Clean the 'B' MAF sensor with dedicated cleaner
Compare 'A' and 'B' readings at idle and under load Tests: Intake leak causing turbulent false-high readings
Inspect the 'B' intake path for leaks or turbulence sources Tests: Intake leak causing turbulent false-high readings
Check the wiring for faults Tests: Wiring fault driving the signal high
Replace the 'B' sensor if it reads high when clean
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$60 – $250
Labor$80 – $200
MAF sensor 'B' cleaning or replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P00BD ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Clean the sensor first; compare against the 'A' sensor's reading.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →