P0048: Turbocharger boost control 'A' circuit high
DIY difficulty 2/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonIf you feel boost surging beyond normal, back off - uncontrolled overboost can hurt the engine. Diagnose before driving hard.
Your boost control circuit is reading too much voltage, so the turbo may be running unregulated. Watch for sudden power surges - overboost can damage the engine.
Key facts
P0048 means turbocharger boost control 'A' circuit high. Your boost control circuit is reading too much voltage, so the turbo may be running unregulated. Watch for sudden power surges - overboost can damage the engine. WrenchFair's published fair-price range for this repair is $40–$150 parts and $80–$200 labor at independent shops.
WrenchFair rates P0048 a 2-of-5 DIY difficulty (“Standard circuit testing; treat overboost symptoms seriously.”) with a “Diagnose soon” driveability rating: If you feel boost surging beyond normal, back off - uncontrolled overboost can hurt the engine. Diagnose before driving hard. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light
possible overboost / power surges
possible limp mode
knock or pinging under load (gasoline)
Likely causes
Boost control wire shorted to battery voltage
Failed solenoid (open coil)
Open in the ECM-controlled ground side
Corroded or damaged connector
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check the fuse feeding the solenoid Tests: Failed solenoid (open coil)
Verify proper voltage and ECM ground control at the solenoid connector Tests: Boost control wire shorted to battery voltage
Unplug the solenoid to isolate a harness fault from a solenoid fault Tests: Failed solenoid (open coil)
Trace the harness for chafing against power feeds
Replace the solenoid if the coil is open
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$40 – $150
Labor$80 – $200
Boost control solenoid replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0048 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Standard circuit testing; treat overboost symptoms seriously.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →