P0013

P0013 on a 2010–2017 Chevrolet Equinox: Exhaust camshaft actuator circuit fault, bank 1

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: P0013 on a 2010–2017 Chevrolet Equinox

DIY difficulty 2/5

The electric valve that adjusts your exhaust camshaft timing on the cylinder-1 side has an electrical fault - usually the solenoid itself or its wiring.

Model notes: 'B' camshaft is typically the exhaust camshaft. Often sets alongside P0014 when the solenoid sticks rather than failing electrically.

Key facts

☑ Before you buy parts — check these first:
On your 2010–2017 Chevrolet Equinox (2.4L Ecotec I4) — VVT camshaft actuator solenoids (P0010/P0013): Owner-verified
Both solenoids sit on top of the engine under the plastic engine cover — no intake manifold removal needed. One 10mm bolt holds each unit.
Do this test first: Inspect the bank 1 exhaust VVT solenoid wiring and connector for damage or corrosion
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0013 on the 2010–2017 Chevrolet Equinox — but the community-sourced VVT camshaft actuator solenoids (P0010/P0013) note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Torque specs

Tips

Sources: tech Q&A · tech Q&A · guide video · owner repair logs

Typical difficulty: Moderate — based on 841 code guides for the sensors repair area (an area-level estimate, not this exact job).

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 5 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Inspect the bank 1 exhaust VVT solenoid wiring and connector for damage or corrosion Tests: Failed VVT oil control valve (solenoid) for the bank 1 exhaust camshaft (most common)
  2. Check the fuse feeding the VVT solenoid circuit Tests: Blown fuse feeding the solenoid circuit
  3. Unplug the solenoid and measure winding resistance against factory spec Tests: Failed VVT oil control valve (solenoid) for the bank 1 exhaust camshaft (most common)
  4. Check harness continuity back to the PCM and test for shorts
  5. Command the solenoid with a bi-directional scan tool if available; replace it if it doesn't respond

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2010–2017 Chevrolet Equinox: VVT camshaft actuator solenoids (P0010/P0013) — test first, then buy for this job.
The price range below is a national planning range for P0013 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$40 – $150
Labor$80 – $250

VVT oil control valve (solenoid) replacement for the bank 1 exhaust camshaft. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0013 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — Same straightforward solenoid-and-wiring diagnosis as P0010, on the exhaust side.

Watch this repair on YouTube

Parts & tools

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →